Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for GasLab SAN-30
Summary of Contents for GasLab SAN-30
- Page 1 Personal Carbon Monoxide Safety Monitor User Manual SAN‐30 ...
-
Page 2: Table Of Contents
MAINTENANCE ..........................7 SPECIFICATIONS ........................... 8 TROUBLESHOOTING ........................9 CO RECOMMENDED LEVELS ....................... 9 SUPPORT ............................9 ............................9 ARRANTY ............................9 ONTACT Copyright © GasLab, Inc. All Rights Reserved PAGE 2 of 9... -
Page 3: Introduction
CO2Meter SAN-30 is a personal safety CO monitor designed to monitor ambient concentrations of carbon monoxide (CO) in real time. CO gas poisoning is the most common type of fatal poisoning in the world. SAN-30 is shipped fully tested and factory calibrated and, with proper use, will provide years of reliable service. -
Page 4: Theory Of Operation
THEORY OF OPERATION The SAN-30 Personal Safety CO Monitor uses an electrochemical sensor to determine the concentration of carbon monoxide in air samples. Air reaches the sensor by diffusing through the openings on the back of the unit. Normal air movement is enough to carry the sample to the sensor. -
Page 5: Operation
Setting Man down alarm function on/off. User presses the power A ON/ AOFF button to switch “A ON” (allowing Man down alarm) or “AOFF” (prohibiting Man down alarm). User presses the power button to exit the menu status. Copyright © GasLab, Inc. All Rights Reserved PAGE 5 of 9... - Page 6 Falling by breathing dangerous gases can cause serious injury and even fatality to workers. If the Man down alarm function in SAN-30 is set on, SAN-30 can detect falls and send a man down alert which will activate the audible and visual alarms and alert other people in the area.
-
Page 7: Co Sensor Cross-Sensitivity
MAINTENANCE Calibration The SAN-30 comes pre-calibrated from the factory. However, the CO sensor should be calibrated at least once a year, or as described in your company’s safety procedures. You can perform the calibration yourself, or you can return it to CO2Meter for factory calibration at a nominal fee. -
Page 8: Specifications
Response Time 5~30 seconds (device must equilibrate with environment) Relative Humidity Sensor Specifications Measurement Range 0.0~99.9%RH Display Resolution 1%RH Accuracy ±4.5%RH Response Time <8 seconds for 63% of step change Copyright © GasLab, Inc. All Rights Reserved PAGE 8 of 9... -
Page 9: Troubleshooting
We are here to help! For information or technical support, please contact us. support@GasLab.com (386) 872-7668 www.GasLab.com GasLab, Inc. 131 Business Center Drive Ste 3 Ormond Beach, FL 32174 USA Copyright © GasLab, Inc. All Rights Reserved PAGE 9 of 9...