Table of Contents
Advertisement
HOW TO MEASURE A LINE
Make sure the MicroSight microscope is plugged into the USB port and the software is open.
Place the microscope down on any ruler and adjust the focus knob until the image is sharp.
Click the
Measurement icon, and the Measurement window will appear.
NOTE: You must calibrate again if you change the distance, magnification, or resolution. Follow
the full calibration directions on page 16.
Select Calibrate
Select the Line Mode
Touch your MicroSight microscope to your specimen. Click the
the Tool Bar. The cross hairs will show on the screen. Move the line to frame the top left of
the image. The measurement represents the diameter as D and the Area as A.
After you have made your measurement, click the Snapshot button or the Save button to save
the measured image.
calibrate the microscope.
Measurement icon on
17
Change the Reference
Unit as desired.
(inches, mm,
cm, etc.)
Change the Reference
to 10 when using cm to
Save the new settings
Advertisement
Table of Contents
