Make Noise soundhack Mimeophon Manual page 14

Understanding the Mimeophon (cont.)
RATE Output
The Rate Output completes the conversation between Mimeophon and the rest of the system, outputting a clock pulse at the
current Rate.
If SKEW is enabled, the resulting two Rates will be OR'ed together, resulting in clock pulses from both Left and Right channels
being output by the Rate Output at once. When externally clocked, this allows the Mimeophon to be used as an unusual dual
clock divider or multiplier. Feed this output to other places in your system to more fully integrate the Mimeophon into your
patch.
Note: at the fastest Rates (Zone 0 and some of Zone 1), the clock is so fast that the Rate output will stay HIGH all the time.
HOLD
The HOLD button temporarily stops the Repeats from changing: no sound will enter or exit the feedback path.
Once the button is pressed (or a gate received at its input), the Mimeophon will ignore the input and continue to Repeat
according to the Zone and Rate controls, with timbre set by the Color and Halo, until the HOLD button is pressed again. While
HOLD is engaged, all other controls remain fully active for constant multi-dimensional manipulation of the Repeats. Any such
manipulation is non-destructive: you can always return to the same Repeats sound indefinitely for as long as HOLD is
engaged.
While HOLD is engaged, Repeats amount is no longer a relevant concept, so the Repeats control instead sets the starting
point of the repeat for the current Zone.
14