Advertisement
6. MAINTENANCE
6.6
Changing the sanding belt.
6.6.1 Referring to fig.1, remove the cover clamp knob (1) and lift off
the clear protective cover (2).
6.6.2 Referring again to fig.1, remove the two belt cover fixing
screws (15) and lift off the black plastic side cover to reveal
the belt and drive wheels as shown in fig.5.
6.6.3 Wheel (E) is spring loaded to hold the belt at the correct
tension.
6.6.4 Push the tracking knob (D) forwards to relieve the tension and
ease the belt off the drive wheels.
6.6.5 Place the new belt onto the upper and lower wheels. Push
knob (D) forwards again and ease the belt back onto wheel (E).
6.6.6 Turn the belt by hand to see if it is running true and make any
necessary adjustments using the tracking knob (C) as
described in Section 4.6.1.
6.6.7 Re-fit the black plastic side cover over the belt and drive
wheels and fix in place using the two fixing screws.
6.6.8 Refit the clear protective cover (2) and hold it in place with the
clamp knob (1).
6.7
Changing the sanding disc.
6.7.1 The abrasive sanding disc has an adhesive backing in order to
attach it to the metal sanding disc.
6.7.2 If fitted, remove the adjustable angle guide from the groove in
the sanding table.
6.7.3 Unscrew and remove the two clamp knobs from either side of
the sanding disc table. Take hold of the front edge of the disc
and pull it away from the disc to remove it.
6.7.4 Remove the four screws that hold the dust extractor cover in
place and put it to one side.
6.7.5 Insert a blade between the back of the abrasive disc and the
surface of the metal disc, taking care not to damage the
metal surface. Ease the abrasive disc away from the metal
surface until you can get hold of it and then peel it away from
the metal disc. Remove any excess adhesive from the surface
of the disc. Peel off the backing from a new abrasive disc and
stick it to the metal disc ensuring it is centred.
6.7.6 Re-attach the exhaust cover and sanding table as described in
Sections 4.1 and 4.2.
Environmental Protection.
Recycle unwanted materials instead of disposing of them as
waste. All tools, accessories and packaging
should be sorted, taken to a recycle centre and disposed of in
a manner which is compatible with the environment.
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
INFORMATION: For a copy of our latest catalogue and promotions call us on 01284 757525 and leave your full name and address, including postcode.
© Jack Sealey Limited
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
Original Language Version
WEEE REGULATIONS. Dispose of this product at the end of
its working life in compliance with the EU Directive on Waste
Electrical and Electronic Equipment. When the product is no
longer required, it must be disposed of in an environmentally
protective way.
01284 757500
W e b
01284 703534
email
www.sealey.co.uk
sales@sealey.co.uk
SM750
Issue No.1
27/11/12
Advertisement
