Download Print this page

ProDVX GM-75 Instruction Manual

Glass mount

ProDVX GM-75 Glass Mount

instruction manual

The ProDVX GM-75 Glass Mounts contains the following parts:

1 x 10" foil / sticker

1 x U-frame (8 x VESA holes)

1 x center block

1x sheet with 2 adhesive strips

4 x short VESA screws (M412)

1 x security screw (cross-recess)

1) Clean the surface with screencleaner spray

Place the foil with the desired size on the glass surface

Table of Contents

Need help?

Do you have a question about the GM-75 and is the answer not in the manual?

Page 1 ProDVX GM-75 Glass Mount instruction manual The ProDVX GM-75 Glass Mounts contains the following parts: 1 x 10” foil / sticker 1 x U-frame (8 x VESA holes) 1 x center block 1x sheet with 2 adhesive strips 4 x short VESA screws (M412)
Page 2 2) Hold the foil on the left side and pull the backside paper out 3) Use a solid straight item to even out the foil...
Page 3 4) Even out big bubbles with the straight item (little bubbles will dissapear with time) 5) Gently pull down the paper from the frontside...
Page 4 7) Slide the center block with the 2 adhesive strips into the U-frame. Screw the U-frame with the center block in it, on the back of the ProDVX display using the 4 VESA screws 8) To secure the display, prepare the security screw by placing the long security screw...
Page 5 9) Remove the tape from the 2 adhesive strips 10) Clean the silver foil/sticker with (ProDVX) screencleaner spray Place the display with the adhesive centre block in the middle of the foil...
Page 6 11) The foil and center block are correctly installed 12) Slide the ProDVX display top-down on the center block 13) Use a Phillips screwdriver to tighten the long security screw on top 14) The ProDVX GM-75 Glass Mount is now successfully installed...