Nufer Medical CERATHERM 600-3 Quick Start Manual page 2

Quick Start Guide CERATHERM 600-3
2
! Read through the instruction manual thoroughly before using the unit !
Supplied CD or on www.nufer-medical.ch/downloads/manual/ceratherm_600-3/
Print version: Nufer Medical AG, Morgenstrasse 148, CH-3018 Bern,
Operation: Switches unit on and off (observe chap. 8)
Display: The unit's operating mode (observe chap. 8)
Operation: Alarm confirmation (observe chap. 8)
Display: Alarm (observe chap. 8 and safety guidelines in chap. 2)
Operation: Preset heat level 1 (20% output)
1
Display: Heat level 1 active
Operation: Preset heat level 2 (50% output)
2
Display: Heat level 2 active
Operation: Preset heat level 3 (75% output)
3
Display: Heat level 3 active
Operation: Preset heat level 4 (98% output)
4
Display: Heat level 4 active
Display: Heating active (observe chap. 8.3)
Operation: Lighting 20% on/off (observe chap. 9)
Display: None
Operation: Lighting 100% on/off (observe chap. 9)
Display: None
Operation: Master switch (supply voltage on/off, see chap. 7)
Display: Mains supply on
Potential equalisation connection.
If the unit is used in a room that corresponds to Category 3 or 4 under
Swiss Low-Voltage Installation Standard NIN / 7.10, this connection must
be connected to the room's potential equalisation connection.
14.179._Quick_Start_Guide_Ceratherm_600_3_PL_EN_DE_FR.doc

+41 (0)31 958 66 66
Nufer Medical AG / 04.09.2017 / DU Seite 2 von 4