Sony STR-DH820 Operating Instructions Manual page 89

• When you connect the receiver to a video
equipment (projector, etc.), sound may not
be output from the receiver. In this case,
select "AMP".
• If you cannot listen to the sound of the
equipment connected to the receiver while
TV input is selected on the receiver
– Be sure to change the input of the
receiver to HDMI when you want to
watch a program on the equipment
connected via HDMI connection to the
receiver.
– Change the TV channel when you want
to watch a TV broadcast.
– Be sure to select the correct equipment
or input you want when you watch a
program from the equipment connected
to the TV. Refer to the operating
instructions of the TV on this operation.
Recording cannot be carried out.
• Check that the equipment is connected
correctly.
• Select the source equipment using the
input buttons (page 43).
Image
No image appears on the TV.
• Select the appropriate input using the input
buttons.
• Set your TV to the appropriate input mode.
• Move your audio equipment away from
the TV.
• Assign the equipment video input
correctly.
• The input signal should be same as the
input function when you are up-converting
an input signal with this receiver
(page 31).
• When you use an HDMI-DVI conversion
cable for the connection, the image may
not be output correctly.
• Make sure that cables are correctly and
securely connected to equipment.
• Depending on the playback equipment,
you may need to set up the equipment.
Refer to the operating instructions
supplied with each equipment.
• Be sure to use a High Speed HDMI cable
when you view images or listen to sound,
especially for the 1080p, Deep Color
(Deep Colour) or 3D transmission.
No 3D image appears on the TV.
• Depending on the TV or the video
equipment, 3D images may not be
displayed.
When the receiver is in standby mode,
there is no image output from the TV.
• When the receiver enters into standby
mode, image is from the last HDMI
component selection before you turned off
the receiver. If you are enjoying other
equipment, play the equipment and
perform the One-Touch Play operation, or
turn on the receiver to select the HDMI
equipment you want to enjoy.
• Make sure "Pass Through" is set to "ON"
in the HDMI Settings menu if you connect
equipment not compatible with the
"BRAVIA" Sync to the receiver (page 73).
Recording cannot be carried out.
• Check that the equipment is connected
correctly.
• Select the source equipment using the
input buttons (page 43).
The GUI menu does not appear on the
TV screen.
• Press GUI MODE repeatedly to select
"GUI ON". If the GUI menu still does not
appear on the TV screen, press MENU.
• Check that the TV is connected correctly.
GB
89