Cleaning And Maintenance; Decommissioning And Recycling - Q CELLS Q.SMART Series Installation And Operation Manual

7 CLEANING AND MAINTENANCE

SAFETY INSTRUCTIONS
CLEANING
MAINTENANCE

8 DECOMMISSIONING AND RECYCLING

16 INSTALLATION AND OPERATION MANUAL FOR CIGS SOLAR MODULES Q-CELLS SE - EUROPE
Q.CELLS CIGS modules are built to last and require minimal maintenance. Light dirt is
typically washed away by rain. However, rain may not adequately clear more stubborn grime
(i.e. pollen, vegetation, bird droppings, etc.). Such soiling which shades the active area of the
module can lead to a reduction in the system's performance.
WARNING! Danger of injury from heated and live modules!
Only clean the modules when the module temperature lies between 10 °C and 30 °C, e.g. in
the early morning or late evening. Do not wear electrically conductive parts. Don't clean dam-
aged modules. This can cause an electric shock.
WARNING! Risk of falling during maintenance of roof installations and building-integrated installations!
Never enter the installation area alone and unsecured. We recommend commissioning a spe-
cialist company to perform this work. Consult your installer on location.
As the operator, you should regularly remove dirt built up from the modules. In addition to the
safety instructions and chapter 3, observe the following points:
• Never step on the modules. Do not subject the modules to mechanical stress.
• Avoid cleaning with water when there is a danger of frost and strong temperature
differences between the module, water and air.
• Hard water used as a cleaning agent should be decalcified beforehand in order to avoid
water staining. Remove any standing water from the module.
• Do not use abrasive detergents or surface-active agents (e.g. soap). Do not scratch dirt off.
This can damage the surface of the module.
Modules must not be covered by snow or ice for a longer period.
Only remove snow and ice without exerting force (e.g. with a broom).
Proceed as follows to remove dirt from the top of the module:
1. Rinse coarse dirt (dust, leaves, etc.) from the module with lukewarm water.
2. Moisten stubborn stains and remove them carefully.
Use lukewarm water and a soft cloth or sponge. Don't put the modules under water. If neces-
sary, it is possible to use isopropanol (IPA) selectively. Follow the safety instructions on the
IPA packaging. Ensure that the IPA does not run off between the module and the frame or into
the module edges.
Free the substructure of dirt (leaves, bird nests, etc.). In the case of ground-mounted instal-
lations, we recommend regularly trimming of the vegetation order to avoid partial shading. Be
sure to pay attention to the cables and stones.
The solar system should be inspected annually by a specialist installer for:
• secure fastening and corrosion-free system components
• secure connection, cleanliness and integrity of all electrical components
• the contact resistances of the grounding.
Do not decommission the module on your own. Commission a specialist company for this
purpose. Q.CELLS is a member of the European PV Cycle Association and accepts our product
responsibility. You can give back modules of Q-Cells SE and allow them to be processed within
the PV Cycle member states. More information can be found at www.pvcycle.com.
If neces-