Summary of Contents for Thunderstone Thunder Power Tarp 6000XR Series
Page 1
THUNDER POWER TARP 6000 OPERATION INSTRUCTIONS 3400 West O Street Lincoln, NE 68528 402-435-4249 (Fax) 402-438-3918 www.thunderstonemfg.com REV D April 8 2019...
Page 2
P a g e USE THE PROCEDURES BELOW TO OPERATE THE TARP SYSTEM Powering up or down the system To turn the system on or off, locate the “Open” and “Close” buttons on the keypad controller on the front of the trailer. Press and hold both buttons simultaneously for approximately 3 seconds. The LED status light and the two large buttons will illuminate when the power is on and ready for operation.
Page 3
P a g e 4. On the keypad controller press and hold the program button (small button), then press and hold the large “Open” button simultaneously. Release both buttons when the status LED turns solid green. The LED will then flash orange rapidly which MODE Lights indicates it is ready to receive remote programming.
Page 4
P a g e MANUAL OPERATION Your Thunder Electric Tarp System should operate smoothly and provide years of service. In the unlikely event that an issue arises with the electric drive motor for the system, please follow these instructions to manually open and close the tarp system.
Need help?
Do you have a question about the Thunder Power Tarp 6000XR Series and is the answer not in the manual?
Questions and answers