Tomar Strobecom II 4140 Getting Started
Hide thumbs
Also See for Strobecom II 4140:
- User manual (18 pages) ,
- Instructions manual (12 pages) ,
- Instructions manual (16 pages)
Advertisement
Instruction
Manual
Strobecom II 4140 and
OSPOC: Getting
Started
Information is provided on how to initially discover
the 4140 and OSPOC on a network and re-configure
it for custom network applications.
IS0592-02
1/13/2014
TOMAR Electronics, Inc.
2100 W. Obispo Ave.
Gilbert, AZ 85233 USA
800.338.3133 ph
800.688.6627 fax
www.tomar.com
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Tomar Strobecom II 4140
Summary of Contents for Tomar Strobecom II 4140
- Page 1 Instruction Manual Strobecom II 4140 and OSPOC: Getting Started Information is provided on how to initially discover the 4140 and OSPOC on a network and re-configure it for custom network applications. TOMAR Electronics, Inc. 2100 W. Obispo Ave. IS0592-02 Gilbert, AZ 85233 USA 1/13/2014 800.338.3133 ph...
- Page 2 REGARDLESS OF THE OPERATION OR NON-OPERATION OF THE STROBECOM II SYSTEM. TOMAR Electronics, Inc. makes every endeavor to ensure the accuracy of its documentation. However, TOMAR Electronics, Inc. is not liable for any inaccuracies contained herein. TOMAR reserves the right to make changes to its products without prior notice.
- Page 3 Table of Contents Introduction ............................4 Networking Module ..........................4 Network Discovery ........................5 Network Configuration ......................... 5 Connecting to the Strobecom II 4140 or OSPOC Using OSPsoft ........... 6 References ............................6 Getting Started Page 3...
-
Page 4: Getting Started
In the default condition, the network is configured as a DHCP client – dynamically obtaining an IP address. In order to configure the networking parameters, free tools from Lantronix are utilized. The steps for configuring the Strobecom II 4140 or OSPOC are outlined as follows and discussed in more detail in subsequent sections. - Page 5 Lantronix devices connected that do not belong to the Strobecom II 4140 or OSPOC product. If connecting directly to a computer, it may take longer for the Strobecom II 4140 or OSPOC to obtain an IP address. Refer to the Device Installer User Guide for additional information on proper subnets.
- Page 6 Connecting to the Strobecom II 4140 or OSPOC Using OSPsoft When connecting to the Strobecom II 4140 or OSPOC using OSPsoft, the network configuration must be known. In particular, the IP address is needed. For communications to OSPsoft on the network, the port to use is 10001.
Need help?
Do you have a question about the Strobecom II 4140 and is the answer not in the manual?
Questions and answers