Receiver; Specifications - RIDGID A-Frame Fault Locator Operator's Manual

Transmitter Display:
Number
1
2
3
4
5
6
7
8
9
Figure 3 – Transmitter Display

Receiver

Battery
Compartment
Figure 4 – A Frame Receiver
999-995-095.10_REV. A
Find Quality Products Online at:
2
3
4
Icons Description
– – – kHz Frequency. "dFF" shown for fault finding.
Signal Power - # Of Bars On Increases with Increasing Power. Three Levels – Low, Medium
and High.
Circuit Information, mA, V or Resistance in Ohms. Transmitter cycles through each at 2
– – –
second intervals.
Voltage Warning – Transmitter connected to energized conductor – risk of electrical shock.
Do not touch transmitter, leads or connections. Use high voltage precautions to disconnect.
Transmitter Set for Fault Finding (dFF displayed in Frequency area (1)).
Transmitter Set for Inductive Clamp Use for Path Locating (Insert Inductive clamp into Jack)
Transmitter Set for Direct Connect Use for Fault Finding or Path Locating.
Transmitter Set for Broadcast Inductive Mode for Path Locating.
Transmitter Battery Status.
Screen and
Serial Label
Warning
Label
Front
Spike
Rear
Spike
GlobalTestSupply
www.
A-Frame Fault Locator
1
Receiver Controls/Display:
1
2
Display
Controls
# Icon Description
Ref
1 Reference Button
Stores and displays starting signal strength when pressed.
2 ON/OFF Button
Main Power Switch – Press to turn unit ON/OFF
3 Directional Arrow
Indicates direction of fault
4 – – Signal Strength
Displays absolute signal Strength from 0 to 99.
5 Low Battery Indicator
Figure 5 – Receiver Controls

Specifications

FT-103 Transmitter:
Operating
Frequencies .......Direct Fault Finding:
5
6
7
8
9
3 4
5
797 Hz - "dFF" displayed
.com
sales@GlobalTestSupply.com
5