ZMODO sPoE NVR system Quick Start Manual
  1. Manuals
  2. Brands
  3. ZMODO Manuals
  4. Security System
  5. sPoE NVR system
  6. Quick start manual
ZMODO sPoE NVR system Quick Start Manual

ZMODO sPoE NVR system Quick Start Manual

Hide thumbs
1
2
3
4
5
6
7
8
Table of Contents

Advertisement

Quick Links

Download this manual
sPoE NVR system
Quick Start Guide

Advertisement

Table of Contents
loading

Related Manuals for ZMODO sPoE NVR system

Summary of Contents for ZMODO sPoE NVR system

  • Page 1 NVR system Quick Start Guide...

  • Page 2: Hdd Installation

    HDD Installation If your system does not include a pre-installed HDD, you can purchase your own and follow the steps below for installation. Make sure you purchase a 3.5" HDD optimized for always-on read/write surveillance, e.g. low-power WD10PURX hard drives. Make sure that your NVR is powered off and unplugged from the power source.
  • Page 3 While keeping the HDD in place, turn the NVR over and line up the holes on the HDD with the holes on the bottom of the NVR. Using the four provided HDD screws, fasten the HDD to the NVR until secure. Replace the cover, and fasten the cover to the NVR using the five provided case screws.

  • Page 4: Power Indicator

    Power indicator: Solid green The NVR is powered on. No light means that the NVR is off. HDD indicator: Solid green There is no HDD, your HDD is not recording, or there is a problem with your HDD. Blinking green The hard drive is recording properly.

  • Page 5: Configuring Your System

    Download and install the “Zmodo” app from Google Play or the App Store (compatibility: iOS 9.0+ or Android 4.0+). Launch the app and sign up for a free Zmodo account. All of your devices will be bound to this account.
  • Page 6 Log into your Zmodo account within 15 minutes of powering on your NVR. The NVR and cameras will be automatically added onto your account. If not, tap the [+] Add Device icon on the upper right corner of the Home Screen. Select the “Wireless Device and Smart Kit” connection method and select the “Smart Kit”...
  • Page 7 Bullet Camera Line the camera bracket against the wall where you would like to install the cameras, and mark the appropriate holes. Drill three holes slightly smaller than the wall anchors and use a hammer to gently insert the anchors into the wall. Fasten the three screws through the holes on the bracket and into the anchors as shown.

  • Page 8: Troubleshooting

    Support Having difficulty? You can use the Live Chat function in Zmodo app if you have any technical problems. Please follow the steps below: Access the “Me” page in the lower right corner in Zmodo app and select "Zmodo Support".

Table of Contents