Advertisement
Quick Links
Advertisement
Related Manuals for Salvo S401
Summary of Contents for Salvo S401
- Page 1 S401 Quick Start Guide V1.1...
- Page 2 60mm Fans (Optional) Note: 60mm x 60mm x15mm fans are recommended. A single 60mm x 60mm x x 12 25mm fan may be used on the bottom mounts, but doing so will interfere with two 2.5” drive mounts and one 3.5” drive mount.
-
Page 3: Main Board
Mainboard Note: Be sure to install mainboard I/O shield before installing mainboard. - Page 4 3 Power Supply Mounting Bracket Note: Orientation of PSU is with FAN intake face up.
- Page 5 4 Power Supply Extension Cable...
- Page 6 Power Supply to Chassis Note: A foam anti-vibration pad has been installed underneath the PSU retaining tab on the chassis. Take care when installing the PSU to ensure the foam pad is not damaged. Before fastening the screws, please check for any interference with the front panel button.
- Page 7 2.5” Drive Install Note: Up to four 2.5” drives can be installed. Use holes labeled S-1, S-2, S-3, and S-4.
- Page 8 6a 2.5” drive mount locations...
- Page 9 3.5” Drive Install Note: Two 3.5” drives may be installed. Use holes labeled H-1 and H-2.
- Page 10 6b 3.5” drive mount locations...
- Page 11 GPU Install Note: Angle GPU with I/O shield down and move toward rear chassis slot.
- Page 12 GPU Install (Cont’d) Note: Be sure to carefully align the PCIe tab from the GPU to the PCIe extender and gently insert.
- Page 13 GPU Install (Cont’d) Note: Tapped holes may strip if GPU screws are over-tightened.
- Page 14 8 Vented Panel Install...
- Page 15 Solid Panel Install...
- Page 16 Stands Note: Be sure orientation of the stand ensures the key fastener aligns with the keyhole on the chassis. Also, stands may be installed on either end of the chassis depending on desired orientation (vertically). If using horizontal orientation, skip to step 11.
- Page 17 Stands (Cont’d)
- Page 18 Handle (Optional Accessory) Note: Like the stands, the handle may be installed on either of two surfaces of the case. If you are using the stands, the handle must be installed on the opposite side of the case as the stands.
- Page 19 Handle (Cont’d)