HP 7090A Operator's Manual page 84

Area Required {or
Time and Dale,
Trigger
1'ime
LabelB.
The default label dirmmsions
A/A4
are shown for paper
BIA3
(in parentheses)
A
Time
and Date Label.
The label shown here is
AIA4
actual s i ze for
Printing the Trigger
Time
A Trigger Time
LabeL
The label shown here
AIA4
actual size for
Labeling Setup
Conditions
6-2 Labeling Functions and Operations
the
an.d
INITAL
aM
paper.
To invoke the label function, press
"SHIFI'" is displayed on the LCD before pressing the
button.) The HP 7090 will access its real-time clock and print the current
time and date using the 24-hour clock notation shown below. (If you need to
set the real-time clock, refer to "Setting the Real-Time Clock" in Chapter 2,)
HOURS MINUTES SECONDS
� '"
paper.
Whenever the HP 7090 receives a valid trigger (including a manual trigger),
the time ofthe trigger occurrence is stored in volatile memory.
trigger time can be labeled on the plotted measurement, Before printing a
trigger time label, select a pen and position it so that the resulting label will
fit within the hard-clip limits of the paper. The area required for the trigger
is
time label the same as that for the time and date label (refer to the
preceding section).
To print the trigger time, press
"SHIFI'" is displayed on the LCD before pressing the
button.) The HP 7090 will print the time at which the most recent trigger
was received, as shown below. (If no trigger time has been received since
power-up, the HP 7090 will print the time of power-up.) A given trigger time
must be labeled before performing a subsequent measurement, as the trig­
ger time label is updated whenever a trigger is received.
is
paper.
The front-panel setup conditions used for a measurement can be labeled on
the hardcopy plot. A setup conditions label inc1udes the range and offset
settings for all three input channels, the total time setting, post- or pre­
trigger time settings, the trigger mode selection, and trigger level and width
(if internal triggering was selected).
Before invoking the labeJing function, select a pen and position it so that
the intended label will fit within the hard-clip limits. The area required for
a typical setup conditions label in relationship to the initial pen position is
Scans by ArtekMedia © 2007
5 . 4 c m
18.1 1
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _
(SHIFT) PRINT TIME.
DAY
\ 1
1 0, 12, 09
3D A P R 8 4
(SHIFT) PRINT TRIG TIME.
HOURS MINUTES SECONDS
""
T R I G T I ME, 1 0 , 1 1 , 45
0. 4 c m
.� _.J
_ _ _ _
(Be certain that
PRINT TIME
push­
MONTH YEAR
/ /
This
recorded
(Be certain that
PRINT TRIG TIME
push­
1 /
-
�
If"
IT:
•
� -
� ..
:! .
II!! .
�
I§
-
-. -
-
- ��
•
- -
!! :
l
---'
i! �
_ J
!! �
��
J
_
i! '
f! �
�
�:;
•
=-.J
�
. � �
�