Sony MHC-GRX5 Operating Instructions Manual page 8

Step 3: Presetting radio stations
(continued)
1
Press TUNER/BAND repeatedly
until the band you want appears in
the display.
The bands you can receive vary
depending on the model you purchased.
Be sure to check which bands you can
receive.
Every time you press this button, the
band changes as follows:
2 band model:
FM ˜ AM
3 band model:
FM n MW n SW
or
FM n MW n LW
4 band model:
FM n MW n LW n UKV*
* "STEREO PLUS" is displayed when
you select UKV.
2
Press and hold + or – until the
frequency indication starts to
change, then release.
Scanning stops when the system tunes in
a station. "TUNED" and "STEREO" (for
a stereo program) appear.
ALL DISCS
8
3
4
5
6
To tune in a station with a weak
signal
Press + or – repeatedly in step 2 to tune in the
station manually.
To change the preset number
Start over from step 1.
To change the AM tuning interval
(Except for the European, Russian and
Middle Eastern models)
The AM tuning interval is factory set to 9 kHz (10
kHz in some areas). To change the AM tuning
interval, tune in any AM station first, then turn off
the power. While holding down the ENTER/NEXT
button, turn the power back on. When you change
the interval, AM preset stations will be erased. To
MONO TUNED
STEREO
reset the interval, repeat the same procedure.
VOLUME
Tip
kHz
MHz
ß
The preset stations are retained for half a day even if
you unplug the power cord or if a power failure
occurs.
Press TUNER MEMORY.
A preset number appears in the display.
ALL DISCS
Turn the jog dial to select the preset
number you want.
Press ENTER/NEXT.
The station is stored.
Repeat steps 1 to 5 to store other
stations.
Preset number
VOLUME
ß