Advertisement
OL-V323-2 Installation Guide
10 Point Touch Overlay for the V323-2
6.0
Integration Procedure
6.1
Place the display face up on a padded surface for overlay integration.
6.1.1
Note that if the unit is already mounted, removing the unit and placing it face up is optional;
integration of the touch screen can also be done while the display is mounted.
6.2
Remove the IR touch screen overlay from packing and verify contents of kit parts.
Remove four (4) bezel retention "L" brackets from the top and bottom of the overlay.
6.3
NOTE: MAINTAIN THE BRACKET ORIENTATION BY TAKING NOTE OF THE SPECIFIC
LOCATION OF EACH BRACKET AS THEY ARE NOT ALL THE SAME!
6.3.1
Retain screws for reuse.
6.4
Clean inside surface of the glass.
6.4.1
Use a glass cleaner or mild cleaning solution to clean glass.
6.4.2
Spray solution onto clean soft cloth then wipe the surface. Spraying cleaning solution directly
onto the monitor may damage the unit.
6.4.3
Use circular motion to avoid smudges and streaks.
6.4.4
DO NOT USE any chemical solvents such as an Acidic, or Alkali solution.
6.5
Place the overlay over the front of the monitor ensuring that the USB cable is coming out the bottom
right corner.
NOTE: ENSURE THE USB CABLE IS NOT PINCHED OR CRUSHED DURING THIS STEP.
NOTE: If installing while wall mounted, DO NOT let go of the overlay until the "L" brackets are
reinstalled.
www.necdisplay.com
NEC Display Solutions of America, Inc.
OL-V323-2
Rev.1.2
3
Advertisement
