Sony MDS-PC2 Operating Instructions Manual page 15

8
Press MENU/NO.
9
If necessary, locate the point on the MD to start
recording from.
If you want to record on a new MD or start recording
from the end of the recorded portion, go to step 10.
To record over from the beginning of an existing MD
track
Press ./> repeatedly until the number of the
track to be recorded over appears.
To record over from the middle of an MD track
Press ./> repeatedly until the number of the
track to be recorded over appears, then press H (or
NX on the deck) to start playback. Press X (or NX
on the deck) at the point you want to start recording
from.
10
Press z.
The deck changes to recording pause.
11
If you have selected "Analog In" in step 4 above,
adjust the recording level.
For details, see "Adjusting the Recording Level" on
page 16.
12
Press H or X (or NX on the deck).
Recording starts.
13
Start playing the program source.
Operations you may want to do during recording
To
Stop recording
Pause recording
Resume recording after pausing
Eject the MD
When you pause recording
The track number increases by one. For example, if you
paused recording while recording track 4, the track
number will be 5 when you resume recording.
Press
x
X (or NX on the deck)
H or X (or NX on the deck)
EJECT Z after stopping
recording
To prevent accidental erasure of the recorded
material
To make it impossible to record on an MD, slide the
record-protect tab in the direction of the arrow (see
illustration below) to open the slot. To enable recording,
close the slot.
Bottom side of the MD
z
To play the tracks you just recorded
Press H (or NX on the deck) immediately after stopping
recording.
The deck starts to play from the first track of the material just
recorded.
z
To play from the first track of the MD after recording
1 Press x again after stopping recording.
2 Press H (or NX on the deck).
The deck starts to play from the first track of the MD.
Note
• You can't record over existing material when Shuffle Play (page
26) or Program Play (page 26) has been selected. "Impossible"
appears in the display at this time.
• You can't use the buttons on the remote or the deck while the
deck is controlled by a personal computer. "REMOTE" appears
in the display at this time.
Record-protect tab
Slide in the
direction of arrow
15 GB