Advertisement
Quick Links
INSTALLATION CERTIFICATE
The undersigned qualified installer attests to have personally fitted the here described detector on the
following vehicle, according to the manufacturer's instructions.
By:
Narcotic Gas
and
Explosive
Gas
Sold on :
Type of device :
911
................................................
Wireless Detector
911
Vehicle :
..........................................................................................................................
INSTALLATION AND USE
MANUAL
UK
GEMINI Technologies S.p.A.
Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia
Reg. n.532-A
Tel. +39 0332 943211 - Fax +39 0332 948080
www.gemini-alarm.com
For all EU Countries
AC 2782UK Rev. 00 - 12/09
Advertisement
Summary of Contents for Gemini 911
- Page 1 ..........Wireless Detector Vehicle : .......................... INSTALLATION AND USE MANUAL GEMINI Technologies S.p.A. Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia Reg. n.532-A Tel. +39 0332 943211 - Fax +39 0332 948080 www.gemini-alarm.com For all EU Countries...
-
Page 2: Introductory Note
PAGE 04 3.2 - LPG EXPLOSIVE GAS ............PAGE 04 Should gas be sprayed into your vehicle, the 911 sensor is able to detect it and - POWER SUPPLY..............PAGE 04 set off an alarm in a few seconds, long before the gas can have any effect on 4.1 - RELAY OUTPUT.............. -
Page 3: Power Supply
The 911 is equipped with a relay that actuates other devices (ex. cabin Silicone vapors in the cabin can deteriorate the detector sensing element. lights or vehicle horn or any other alarm device). -
Page 4: Signal Symbols
D E S C R I P T I O N 10.0 - INSTALLATION The 911 detector is intended for a permanent installation. G r e e n S u p p l y v o l t a g e p r e s e n t The device must be positioned at about 20-40 cm from the vehicle cabin floor to be protected. -
Page 5: Relay Output Connections
For safety reasons, always insert a protection fuse (3-4A max.) between the device to be managed and the detector contacts. Min 1 meter Max 5 meter Model 911 20/40 cm 12.0 - CIRCUIT DIAGRAM Alarm output Card fixing screw - Screw-type terminal block to connect alarm output contact. - Page 6 14.0 - TECHNICAL SPECIFICATIONS Power supply selectable via the 12Vcc (10 to 14Vcc) SL1 switch 24Vcc (20 to 28Vcc) Maximum absorption 100mA Alarm sound pressure level 90dB at 30 cm Working temperature Da +5°C a +45°C Dimensions 117 x 68 x 35 mm Protection level Ip40 Plastic casing...