Sony HT-DDW700 Operating Instructions (HTDDW700 Home Theater System) Operating Instructions Manual page 13

Installing the speakers on the
wall
You can install your front and surround
speakers on the wall.
1
Prepare screws (not supplied)
that are suitable for the hole on
the back of each speaker as
shown in the illustrations
below.
more than 1 inch
3/16 inch
13/32 inch
Hole on the back of the speaker
2
Fasten the screws to the wall.
The screws should protrude to
7/32 to 9/32 inch.
7/32 to 9/32 inch
more than 5/32 inch
3
Hang the speakers on the
screws.
Hole on the back of the speaker
Notes
• Use screws that are suitable for the wall material
and strength. As a plaster board wall is especially
fragile, attach the screws securely to a beam and
fasten them to the wall. Install the speakers on a
vertical and flat wall where reinforcement is
applied.
• Contact a screw shop or installer regarding the wall
material or screws to be used.
• Sony is not responsible for accident or damage
caused by improper installation, insufficient wall
strength or improper screw installation, natural
calamity, etc.
3/16 inch
13/32 inch
13
US