Connecting Optional A/V Components And Outdoor Aerials - Sony DHC-MD313 Primary Operating Instructions Manual

Connecting optional
A/V components and
outdoor aerials
To enhance your system, you can connect
optional components. Refer to the
instructions of each component.
Connecting audio
components
Connect the plugs from the optional
component to jacks of the same colour on the
rear panel of this unit.
To the audio
input of a
tape deck.
To the audio output of
a tape deck.
To the AU BUS connector
of the TC-TX313 stereo
SIGNAL GND
cassette deck.
Tip
When you connect the TC-TX313 stereo cassette
deck to the DHC-MD313, be sure to use the AU BUS
terminals.
To listen to analogue components
(except for the optional tape deck
TC-TX313)
If the sound from a connected component is
distorted, reduce the input level.
1 Press FUNCTION repeatedly until "TAPE"
appears.
2 Turn off the system by pressing POWER.
3 While holding FUNCTION down, press
POWER again.
"Attenuate ON" appears and "ATT"
flashes in the display.
A t t e n u
To reset to the original level, repeat steps 1, 2,
and 3.
ATT LEVEL SYNC -
DBFB
a t e O N
continued
9