MSI X470 GAMING PLUS User Manual page 47

fParallel (LPT) Port Settings [Auto]
Sets parallel port (LPT). If set to Auto, BIOS will optimize the IRQ automatically or
you can set it manually.
fDevice Mode [STD Printer Mode]
Selects an operating mode for parallel port.
[STD Printer Mode]
[SPP]
[EPP-1.9 and SPP Mode]
f Hardware Monitor
Sets the fan speeds. Press Enter to enter the sub-menu.
f Power Management Setup
Sets system Power Management of ErP and AC Power Loss behaviors. Press Enter to
enter the sub-menu.
fErP Ready [Disabled]
Enables or disables the system power consumption according to ErP regulation.
[Enabled] Optimize the system power consumption according to ErP
regulation. It will not support S4 & S5 wake up by USB, PCI and PCIe
devices.
[Disabled] Disables this function.
fRestore after AC Power Loss [Power Off]
Sets the system behaviors while encountering the AC power loss.
[Power Off] Leaves the system in power off state after restoring AC power.
[Power On] Boot up the system after restoring AC power.
[Last State] Restores the system to the previous state (power on/ power off)
before AC power loss.
fSystem Power Fault Protection [Disabled]
Enables or disables the system to boot up when detecting abnormal voltage input.
[Enabled] Protect the system from unexpected power operating and remain
the shut down status.
[Disabled] Disables this function.
f Windows OS Configuration
Sets Windows detailed configuration and behaviors. Press Enter to enter the sub-
menu.
fBIOS UEFI/CSM Mode [CSM]
Select CSM (Compatibility Support Module) or UEFI mode to meet the system
requirement.
[CSM] For the non-UEFI driver add-on devices or non-UEFI mode OS.
[UEFI] For the UEFI driver add-on devices and UEFI mode OS.
Printer port mode
Standard Parallel Port mode
Enhanced Parallel Port-1.9 mode + Standard
Parallel Port mode.
47
BIOS Setup