Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Vanderbilt CHSM2210-B
Summary of Contents for Vanderbilt CHSM2210-B
- Page 1 CHSM2210/2211-B Medium Camera Housing with Integrated Bracket Installation Guide...
- Page 2 Data and design subject to change without notice. / Supply subject to availability. © 2016 Copyright by Vanderbilt We reserve all rights in this document and in the subject thereof. By acceptance of the document the recipient acknowledges these rights and undertakes not to publish the document nor the subject thereof in full or in part, nor to make them available to any third party without our prior express written authorization, nor to use it for any purpose other than for which it was delivered to him.
-
Page 3: Table Of Contents
Ceiling mount bracket ................14 Fitting the camera and lens ..............15 Mounting the camera housing assembly ..........16 Connecting to the power supply .............. 18 Adjusting the sunshield ................19 Maintenance and service ..............20 Disposal ....................20 © Vanderbilt 2016... - Page 4 © Vanderbilt 2016...
-
Page 5: Safety
The fuse for the device and the fuse for the electrical system of the building must be installed separately. Risk of cable damage due to stress Use only cable types that are approved for the environmental requirements. The cable glands used must be appropriate for the cable diameter. © Vanderbilt 2016... -
Page 6: Meaning Of The Signal Words
Type of risk CAUTION There is a risk of minor to medium injuries or damage to property IMPORTANT Malfunctioning may result Meaning of the hazard symbols The nature of the hazard is indicated by icons. Warning of a hazard © Vanderbilt 2016... -
Page 7: Eu Directives
EN 61000-3-2 EN 61000-3-3 EN 55022 Class B Resistance to interference: EN 50130-4 European Directive 2006/95/EC „Low-Voltage Directive” Compliance with the European Directive 2006/95/EC has been proven by testing according to the following standard: Safety: EN 60950-1 © Vanderbilt 2016... -
Page 8: Technical Data
Nominal Voltage CHSM2211-B: 12 – 24 V AC 50/60 Hz Fuse Rating (Fuse F1) CHSM2210-B: 2 A 250 V AC 5 x 20 Type (T), HBC CHSM2211-B: 5 A 250 V AC 5 x 20 Type (T), HBC Electrical Connections Main supply connections via fused PCB mounted terminal blocks. -
Page 9: Mechanical Dimensions
574 mm 169 mm 17° 458 mm 108° without tilt 133 mm 108 mm 76 mm 504 mm 66 mm 547 mm 125 mm 113° 3 mm 108° without tilt 163 mm 108 mm 127 mm 504 mm © Vanderbilt 2016... -
Page 10: Key To Parts
Technical data Key to parts Fig. 2 Key to Parts Front End Cap Housing Body Sunshield Rear End Cap Cable Glands Terminal Board Camera Mounting Plate Demister Assembly Window Bracket Assembly © Vanderbilt 2016... -
Page 11: Package Contents
Shoulder washer (to insulate screw from camera mounting plate) NOTE The complete assembly should be mounted and tested in the workshop prior to use on-site. Accessories Type Designation CAPD1210-C230 12 V DC 500 mA PSU 230 V AC input CHBA-221X-B Ceiling Mount Bracket © Vanderbilt 2016... -
Page 12: Installation
M4 screws which secure the housing to the rear cap should be retightened to a torque of 2 Nm. Fig. 3 Inside the housing enclosure Sun Shield Demister Termination Board Rear Cap Camera Mounting Plate Housing Cover © Vanderbilt 2016... -
Page 13: Fitting The Accessories
5.2.1 Power supply modules In some installations the camera requires a 12 V DC power supply; Vanderbilt power supply module CAPD1210-C230 is available and mounts inside the rear end cap (see Fig. 4). It is fused by connecting it through the terminal board. To fit the... -
Page 14: Ceiling Mount Bracket
5.2.2 Ceiling mount bracket A ceiling mount bracket CHBA-221X-B is available for the housing which rotates the mounting surface by 90 degrees to allow mounting onto a ceiling. An installation instruction is supplied with the bracket. © Vanderbilt 2016... -
Page 15: Fitting The Camera And Lens
Terminate and connect the necessary video signal cable to the camera (e.g. coax cable). Fig. 6 Fitting the camera and lens Camera Spacer block Camera plate insulator Adjustment location slot Shoulder washer Mounting screw (1/4 BSW) 1/2” or 3/4” © Vanderbilt 2016... -
Page 16: Mounting The Camera Housing Assembly
10. Move the camera housing to the required position and tighten the two M6 Cap Head screws to fix in position. It is important to ensure that the toothed lock washers are still in place after installation. 11. Refit the housing cover as described in section 5.1. © Vanderbilt 2016... - Page 17 Wall bracket section – replace with ceiling mount option (CHBA-221X-B) if required Sections are held together with 2 M6 screws and 2 x toothed lock washers Centre section Flat area top and bottom 4 8.5 mm diameter through holes on a 4“ (101.6 mm) PCD © Vanderbilt 2016...
-
Page 18: Connecting To The Power Supply
As part of the CAUTION building installation, protect the unit via a fuse or circuit breaker rated at 2 A for CHSM2210-B 110 – 230 V AC units and 5 A for CHSM2211-B 12– 24 V AC units. NOTE Use only cable suitable for the application and that meets the standards required by the installation. -
Page 19: Adjusting The Sunshield
Installation Adjusting the sunshield Firmly squeeze (A) the sides of the sunshield (see Fig. 9). Slide (B) the sunshield to the required position. Release the sunshield and it will remain in position. Fig. 9 Sunshield adjustment © Vanderbilt 2016... -
Page 20: Maintenance And Service
Neither do they constitute or amend any earlier or existing commitment or legal relationship. All obligations on the part of Vanderbilt result from the relevant purchase agreement which also contains the complete and solely valid warranty regulations. This installation guide neither extends nor restricts these contractual warranty regulations. - Page 22 Issued by Vanderbilt © Vanderbilt 2016 Clonshaugh Business and Technology Park Data and design subject to change without notice Clonshaugh Supply subject to availability Dublin 17 Document no.: C-301054 Ireland Document version: 2.0 www.vanderbiltindustries.com Edition:4/14/2016...
Need help?
Do you have a question about the CHSM2210-B and is the answer not in the manual?
Questions and answers