Table of Contents
Advertisement
Technical Specifications
COMPONENT
Square drive
Free speed
Max. torque
Avg. air consumption
Working pressure
Air inlet
Air hose
Assembly Instructions
1. Remove the air inlet protective cap from the air inlet (E).
(See Figure 1)
2. Place 2 - 3 drops of air tool oil (not included) into the male
plug before each use. (See Figure 2)
3. Choose the correct impact socket (not provided) as needed
and mount it onto the anvil (B). (See Figure 3)
WARNING
Only use impact sockets that have a
RPM rating equal to or greater than the tool itself.
B
4. If longer reach is necessary, use an extension bar
(not included) and then mount impact socket onto the bar.
SPECIFICATIONS
1/2 in. (12.70 mm)
7,000 RPM
500 ft.-lbs.
6.5 CFM
90 PSI
1/4 in. (6.35 mm) NPT (F)
3/8 in. (9.53 mm) (inner diameter)
E
Figure 1
Figure 2
Figure 3
5. Mount a leader hose (not included) by hand into the air
inlet (E). (See Figure 4)
NOTE Use thread sealant tape (not included) on the male
plug and tighten it with a wrench for airtight connection.
Do not overtighten.
6. Connect air supply hose to the leader hose.
7. Set the working pressure at 90 PSI/6.3 bar for best tool
performance.
Operation Instructions
Forward/Reverse rotation is selected by pushing the F/R valve
knob in the direction shown by the arrow on the back of
the wrench.
1. How to install/tighten threaded fasteners
Push the F/R valve knob (D) backward. Press the
trigger (C). Then the tool anvil (B) runs clockwise.
(See Figure 5)
2. How to remove/loosen threaded fasteners
Push the F/R valve knob (D) forward. Press the
trigger (C). Then the tool anvil (B) runs counterclockwise.
(See Figure 5)
D
Figure 5
NOTE This tool features a power regulator valve. Rotate the
F/R valve knob (D) until desired output is achieved. The
settings 1, 2, 3 are only for reference and do not denote a
specific power output. "Setting 1" is the least amount of power
while "Setting 4" is most amount of power. Rotate the F/R
valve knob (D) either clockwise or counterclockwise having
the triangle mark or hollow line on the knob (D) pointing at
any setting to get the desired power.
E
Figure 4
5
Advertisement
Table of Contents
