Page 2
WP9038ADAM User’s Manual V1.42 、 P roduct description 6 ch single terminal analog input (DC 0-20mA/4-20mA),using independent 12 bit industrial AD collection chip 4 ch optoelectronic isolation digital input and output (NPN transistor open collector output) Using RS485 MODBUS RTU communication standard. It can be netted with configuration software, PLC and industry...
Page 3
WP9038ADAM User’s Manual V1.42 4.2 、 d igital output diagram 4.3 、 a nalog input diagram 、 C ommunication Instruction 5.1 、 C ommunication parameter (default setting) : 9600 , N , 8 , 1 Parameter Description 9600 baud rate...
Page 4
WP9038ADAM User’s Manual V1.42 0769 read data 0769-read data from the first analog input 0000 0000-read data from the second analog input 0000 0000-read data from the third analog input 0000 0000-read data from the fourth analog input 0000 0000-read data from the fifth analog input...
Page 5
WP9038ADAM User’s Manual V1.42 When module receives correct command, it will make corresponding actions and send response back to the master. This is successful communication. 5.6 、 C ommand for state collection of digital output : Send: 01 01 00 00 00 04 3D C9 ( e xample/hexadecimal )...
Page 6
WP9038ADAM User’s Manual V1.42 Receive : 0 1 06 00 65 00 02 18 14 ( e xample/hexadecimal ) This command means to send a code to the module and set the communication parameter as “9600, N (No check), 8, 1”.This setting could be saved when power off.