Presetting Radio Stations - Sony STR-GA7ES Operating Instructions Manual

Receiver Operations
5
Press the numeric buttons to enter the frequency.
Example 1:FM 102.50 MHz
1 0
6
When you tune in AM stations, adjust the
direction of the AM loop antenna for optimum
reception.
To receive other stations
Repeat Steps 3, 4 and 5.
If the STEREO indicator remains off
Press FM MODE even when an FM stereo broadcast is
received.
If an FM stereo program is distorted
The STEREO indicator flashes. Press FM MODE to
change to monaural (MONO). You will not have the
stereo effect but the distortion will be reduced. To
return to the auto stereo mode, press this button again.
If you cannot tune in a station and the entered
numbers are flashing
Make sure you've entered the right frequency. If not,
reenter the frequency you want.
If the entered numbers still flash, the frequency is not
used in your area.
To watch FM simulcast TV programs
Make sure that you tune in the simulcast program on
both the TV (or VCR) and the receiver.
If you enter a frequency not covered by the tuning
interval
The entered value is automatically rounded up or down
to the closest covered value.
Tuning intervals for direct tuning are:
FM: 50 kHz intervals
AM: 10 kHz intervals (to change to 9 kHz intervals, see
page 27)
Receiving broadcasts by scanning stations
(automatic tuning)
If you don't know the frequency of the radio station
you want, you can have the receiver scan all the
receivable stations to locate the one you want.
1
Select TUNER.
The last received station is tuned in.
2
Press DISPLAY so that the frequency appears in
the display.
3
Press FM/AM to select FM or AM.
12 EN
Example 2:AM 1350kHz
(You don't have to enter
2 5 0
the last "0.")
1 3
4
Press INDEX + or –.
Press the + button for a higher station number;
press the – button for a lower one. When you tune
past either end of the band, the receiver
automatically jumps to the opposite end and
5
continues scanning in the same direction. Every
time a station is received, the receiver stops
scanning. To continue scanning, press the button
again.

Presetting Radio Stations

You'll most likely want to preset the receiver with the
radio stations you listen to often so that you don't have
to tune in the station every time. The receiver can store
a total of 30 FM or AM stations. You can store the
stations on preset numbers combining 3 characters (A,
B and C) and numbers (0-9). For example, you can
store a station as preset number A1, B6, or C9.
SHIFT
1
Turn FUNCTION to select "TUNER".
The last received station is tuned in.
2
Tune in the station you want.
If you are not familiar with how to tune in a
station, see "Receiving Broadcasts" on the
previous page.
3
Press MEMORY.
"MEMORY" appears for a few seconds.
Do steps 4 and 5 before "MEMORY" goes out.
4
Press SHIFT to select a memory page (A, B or C).
Each time you press SHIFT, the letter "A", "B" or
"C" appear in the display.
5
Press the number you want to use (0 to 9).
If "MEMORY" goes out before you specify the preset
number, start again from step 3.
6
Repeat steps 2 to 5 to preset other stations.
To change a preset station
Preset a new station on the number you want to change.
Numeric buttons FUNCTION
PRESET MEMORY
– / +