Emptying The Dirt Tank; Cleaning The Filter - Bissell 3-IN-1 Turbo Vac 2610 Series User Manual

Emptying the Dirt Tank

WARNING
» To reduce the risk of electrical shock, turn Power Switch OFF and disconnect polarized plug from
electrical outlet before performing maintenance or troubleshooting checks.
» Do not operate vacuum with damp or wet filters or without all filters in place.
1
3
NOTE: The Dirt Tank may be rinsed with warm water and a mild detergent if needed.
The Dirt Tank must be thoroughly dried before replacing.

Cleaning the Filter

1
Follow the steps above to remove Dirt
Tank and Filter. To clean the Filter, shake
it over a trash bin and gently tap against
side until al debris is gone.
NOTE: After heavy usage, you may clean the Filter by washing it gently by hand in warm
water and mild dish detergent. Rinse thoroughly and make certain it is completely dry
before replacing it. If Filter is torn, replace it with a new Filter.
Turn the vacuum OFF
and hold it vertically,
pressing the Dirt
Tank release latch.
Gently pull the Dirt
Tank from the hand
vacuum.
Empty contents
of Dirt Tank into a
trash bin, and gently
tap against side to
remove any build up.
2
4
2
Return filter to Dirt
Tank and follow
instructions above to
return the Dirt Tank to
vacuum, making sure it
is correctly secured.
Grip and remove
the Filter.
Replace Filter.
Attach Dirt Tank to
vacuum by securely
fitting onto hand
grip. Make sure Dirt
Tank is correctly
secured.
www.BISSELL.com
5