MCS-WIRELESS-MODEM
Chapter - 4.
4.1.
QUICK START
Attach the Dual Band Antenna, thumb tight only.
4.2.
CONNECT TO MCS-MAGNUM
4.3.
NETWORK ADDRESS ON MCS-MAGNUM
THE NETWORK ADDRESS FOR YOUR
NEW MCS-WIRELESS-MODEM HAS BEEN
FACTORY SET AND IS SUPPLIED WITH THE UNIT.
YOU MUST SET THE NETWORK ADDRESS ON YOUR CONTROLLER TO MATCH THIS FACTORY
ADDRESS.
4.4.
CONNECTING CROSS OVER CABLE
Connect the end of the supplied CROSSOVER ETHERNET CABLE to the ETHERNET DATA
SOURCE connector on the rear of the MCS-WIRELESS-MODEM and the other end to the IO port on
the MCS-MAGNUM CONTROLLER.
4.5.
POWER SUPPLY
Plug the power supply into an electrical outlet and connect it to the router.
Make sure the power is switched on.
O = OFF
I = ON
4.6.
ACTIVATE YOUR MODEM
A wireless broadband data plan has been added to your MCS-WIRELESS-MODEM through Verizon
Wireless.
If there are any problems or questions about the intallation of the data plan, please consult MCS
support at: support@mcscontrols.com
BASIC SETUP
THIS IS A FACTORY PRE-INSTALL.
7
REVISION 2.0
Ethernet Cross Over
Cable supplied