Ecodyne Water Systems HPF Installation, Operation, Maintenance & Repair Parts

Automatic water filtration with high-flow 1” valve

Advertisement

Quick Links

AUTOMATIC WATER FILTRATION
Chloramine, Chlorine Taste, Odor
Water Neutralizer
Models NSAPFSSA & NSAPFXLA
Installation
Point-of-entry systems NSAPFSSA and
NSAPFXLA tested and certified without media by
the Water Quality Association under NSF/ANSI
Standard 61 for material safety requirements
only, and NSF/ANSI Standard 372 for low lead
content. Not certified for contaminant reductions
by the Water Quality Association.
Designed, Engineered &
Assembled in the U.S.A.
with High-Flow 1" Valve
& Sediment Filter
Model NSCCTOSSA
All Purpose Filter
Operation
Manufactured and warranted by
Ecodyne Water Systems
1890 Woodlane Drive
Woodbury, MN 55125
Model NSANSSA
Maintenance
Repair Parts
7341148 (Rev. H 11/15/18)

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the HPF and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Ecodyne Water Systems HPF

  • Page 1 Standard 61 for material safety requirements only, and NSF/ANSI Standard 372 for low lead content. Not certified for contaminant reductions by the Water Quality Association. Manufactured and warranted by Ecodyne Water Systems 1890 Woodlane Drive Designed, Engineered & Woodbury, MN 55125 7341148 (Rev. H 11/15/18)
  • Page 2: Table Of Contents

    TABLE OF CONTENTS Page Specifications & Dimensions ..............3 General Filter Information .
  • Page 3: Specifications & Dimensions

    Specifications & Dimensions Chloramine, Chlorine Taste, Odor & Sediment Filter 10” APF 12” APF Neutralizer   NSCCTOSSA NSANSSA NSAPFSSA NSAPFXLA Model Code Neutralite/ Type of Mineral Catalytic Carbon   Magnesium Oxide Amount of Mineral 0.71 cu. ft. 1.0 cu. ft. ...
  • Page 4: General Filter Information

    General Filter Information SEDIMENT FILTER WATER NEUTRALIZING FILTER A sediment filter removes sand, dirt, clay, silt, and fine All water, when chemically analyzed, is either acid, organic matter from water. You can see sediment in neutral, or base (alkaline). To quantify this, the water water by filling a clear drinking glass and holding it up is given a pH value between 0 and 14.
  • Page 5: Before Starting Installation

    Before Starting Installation WHERE TO INSTALL THE FILTER TOOLS, PIPE & FITTINGS, OTHER MATERIALS YOU WILL NEED Place the filter as close as possible to the pressure tank (well system) or water meter (city water). Plastic inlet and outlet fittings included with the filter allow water flow equivalent to 1 inch nominal pipe.
  • Page 6: Media Loading - Apf Models Only

    Media Loading - APF Models Only MEDIA LOADING Top Edge of Riser Pipe Top Distributor Models NSAPFSSA & NSAPFXLA, as manufactured, 0” to 1/2” have no media in the tank. Before plumbing the unit, load gravel, sand and mineral (See table on Page 3 for amounts): 1.
  • Page 7: Typical Installation Illustrations

    Typical Installation Illustrations INSTALLATION USING INCLUDED BYPASS VALVE CROSS-OVER Use if water supply flows from the left. Filtered Include single or 3-valve bypass. Water OUT UNFILTERED FILTERED WATER Unfiltered WATER Water IN FROM FILTER TO FILTER OUTLET INLET 120V, INSTALLATION USING 3-VALVE BYPASS 60 Hz Outlet Unfiltered Water...
  • Page 8: Installation Instructions

    Installation Instructions Clip (2) IMPORTANT SANITIZING PROCEDURES Care is taken at the factory to keep your water filter Plastic installation clean and sanitary. Materials used to make the fil- OUTLET adaptors (install in ter will not infect or contaminate your water sup- filter valve or ply, and will not cause bacteria to form or grow.
  • Page 9 Installation Instructions 3. COMPLETE PLUMBING TO AND FROM 5. INSTALL VALVE DRAIN HOSE THE FILTER a. Take a length of 5/8” inside diameter garden hose and attach to the valve drain fitting (See Figure 7 on Using the “Typical Installation Illustrations” on page 7 page 7).
  • Page 10 Installation Instructions 8. PROGRAM THE TIMER continued from previous page e. After about three minutes, open a HOT water faucet See pages 11 & 12 for instructions to program the timer. for one minute, or until all air is expelled, then close. f.
  • Page 11: Programming The Electronic Controller

    Programming the Electronic Controller Display UP button DOWN button TOUCH/HOLD button SELECT button FIG. 13 CONTROLLER SETTINGS REQUIRED B. SET DAYS BETWEEN RECHARGES upon installation, and after an extended power outage. 1. If you completed the previous step, the word When the power supply is plugged into the electrical “RECHARGE"...
  • Page 12: Customizing Features / Options

    Programming the Electronic Controller 2. The filter’s default recharge start time is 12:00 AM. continued from previous page This is normally a time of day when water is not C. SET RECHARGE START TIME being used in the household. If you have a water softener or another filter installed, the recharge 1.
  • Page 13 Controller Features / Options RECHARGE CYCLE TIME ADJUSTMENTS 2. Use the UP or DOWN buttons to adjust solu- tion draw / rinse time from 0 to 255 minutes. The default durations for fill (0 minutes), solution draw 3. When the desired draw time is displayed, press the / rinse (0 minutes), backwash (25 minutes), and fast SELECT button, and the display will change to rinse ( 5 minutes), are factory set for maximum filter...
  • Page 14 Controller Features / Options 1. Press and hold the SELECT button until “000 - -” continued from previous page shows in the display (See Figure 27). E. ADJUSTABLE FAST RINSE TIME 1. If you completed the previous step, the fast rinse time adjust screen should show in the display (See Figure 26).
  • Page 15: General Filter Maintenance

    General Filter Maintenance The filters require a minimum of care. A backwash at dissolve away (see below). The activated carbon in a regular intervals will keep the filter mineral bed clean taste & odor filter will need to be replaced after it has and operating at top efficiency.
  • Page 16 General Filter Maintenance REPLACING MINERAL IN THE TASTE & ODOR FILTER The activated carbon mineral adsorbs tastes and/or O-Ring, O-Ring, odors in the water supply. How long it lasts depends 2-7/8” x 3-1/4” 13/16” x 1-1/16” on how much water is used, and other conditions. (thick) Average life of the mineral is about one year.
  • Page 17 Troubleshooting Guide CHECKLIST BEFORE YOU CALL FOR SERVICE PROBLEM CAUSE CORRECTION Filter will not regen- Manual plumbing bypass valve(s) in Refer to figures 6 and 7 on page 7, and posi- erate bypass position. tion for filtered water ‘‘service’’. Power supply unplugged at wall outlet, Check for loss of power and correct as need- fuse blown/circuit breaker popped, circuit ed.
  • Page 18: Troubleshooting

    Schematic WIRING SCHEMATIC Back of Electronic Controller (PWA) Power Motor Pos./Turbine Power Supply 120V AC Valve 24V DC 60 Hz Motor 24V DC Position Auxiliary Output FIG. 32 Switch Troubleshooting AUTOMATIC ELECTRONIC DIAGNOSTICS TO REMOVE AN ERROR CODE: 1. Unplug the power supply. This filter has a self-diagnostic function for the electri- cal system.
  • Page 19 Troubleshooting (continued) MANUALLY INITIATED ELECTRONIC DIAGNOSTICS Use the following procedures to advance the filter Position markers through the recharge cycles to check operation. (valve in service) Remove the top cover faceplate assembly by unlock- ing the tabs and lifting, to observe cam and switch operation during valve rotation (See Figure 36).
  • Page 20 Troubleshooting SERVICE Valve Cam Position Switch FIG. 37 FILL Valve Cam Position Switch FIG. 38 BRINE DRAW Valve Cam Position Switch FIG. 39 BACKWASH Valve Cam Position Switch FIG. 40 FAST RINSE Valve Cam Position Switch FIG. 41...
  • Page 21: Exploded View & Parts List

    Neutralite, 1/2 cu. ft. bag 7161912 (Water Neutralizer) 0501783 Filter Sand, 10 lbs. 7124415 Gravel, 17 lbs. 7302039 Tank Foot, 10” Tank 7339222 Tank Foot, 12” Tank Not illustrated. ¢ Manufactured and warranted by Ecodyne Water Systems 1890 Woodlane Drive Woodbury, MN 55125...
  • Page 22 Valve Exploded View Flow Plug Assembly Assembled View Wear Strip Seal Cross-section View...
  • Page 23 (See Key Nos. 70 & 72) Seal, Nozzle & Venturi 7248706 Ground Clamp Kit Ù 7174313 Bearing, Wave Washer 7185500 Rotor & Disc Not included with the system. Ù Manufactured and warranted by Ecodyne Water Systems 1890 Woodlane Drive Woodbury, MN 55125...
  • Page 24: Warranty

    WATER FILTER WARRANTY Warrantor: Ecodyne Water Conditioning, P.O. Box 64420, St. Paul, MN 55164-0420 Warrantor guarantees, to the original owner, that: One Year Full Warranty: ● For a period of one (1) year from the date of purchase, all parts will be free from defects in materials and workman- ship and will perform their normal functions.

Table of Contents