Alarm ADC-ACC1-17 Quick Start Manual page 4

Expanded configuration - ADC-ACC2-34*
Add up to 16 expansion modules to the ADC-ACC2-34 to
control up to 34 readers.
❶ ADC-ACC2-34
❷ ADC-ACX2
❸ ADC-ACX1
❹ Reader
❺ Reader
❻ Reader
❼ Reader
Reader
For detailed wiring guides, please see the device installation manuals.
*You may add up to 68 readers on a single account.
4
Add hardware to Alarm.com account
Controllers
1. Disconnect any Ethernet cables from all controllers
in the system.
2. Navigate to the Access Control tab on the
Equipment page on the Partner Portal.
3. Add a controller using the "Add Controller" button.
Follow on-screen instructions. You'll need the
controller's MAC address, which is located on
the side of the Ethernet port.
4. Repeat for all additional controllers in the system.
Expansion modules (If none, skip to step 7)
5. To add an expansion module to a controller,
click the "Add Expansion Module" link displayed
next to the controller in the Controllers table.
Follow on-screen instructions.
6. Repeat for all expansion modules in the system.
Doors
7. To add doors to a module, click the "Add Door" link
displayed next to the module in the Devices table.
Follow on-screen instructions.
8. Repeat for all doors in the system.
Check connection
9. Connect an internet-connected Ethernet cable
to each controller and power up the system.
10. Check the Event History on the Partner Portal to
make sure the controller is communicating.
5