Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Darkglass Electronics Microtubes X Ultra
Summary of Contents for Darkglass Electronics Microtubes X Ultra
- Page 3 Warning The Microtubes X Ultra has a current draw of 200mA. Only use a regulated 9V DC adapter with a center-negative plug. Due to ecological reasons, it does not accept batteries. Unregulated...
- Page 4 Controls High Pass Frequency: Controls the cutoff frequency to be distorted, ranging from 100Hz (for thicker, fuzzier saturation) or 1kHz for ultra-sharp definition. High Drive: Sets the amount of distortion for the high pass side. High Level: Sets the output volume of the distorted high-pass signal. Low Pass Frequency: Controls the cut-off frequency to be mixed back to the high-pass side.
- Page 5 Output. This switch completely bypasses all digital circuits and allows you to get a zero latency signal when needed. Headphones: Microtubes X Ultra has a digitally controlled headphone amplifier with a 3.5mm stereo jack output. Digital volume control is available in Darkglass Suite.
- Page 6 Technical Specifications Single user loadable cabinet simulation impulse response · Maximum impulse length 21 ms · 48 kHz, 16-bit internal processing · 1.6 ms latency · 92 dB dynamic range Micro-USB B port to connect to PC/Mac 3.5mm headphone output with cabinet simulation: ·...
- Page 7 IR files. See the online manual of Darkglass Suite for more information. The Bus Compressor on the Microtubes X Ultra can be enabled for the clean channel in Darkglass Suite. You can enable tooltips ('?' symbol in the top right corner) and hover the mouse over different functions for additional information.
Need help?
Do you have a question about the Microtubes X Ultra and is the answer not in the manual?
Questions and answers