CPN 5600/6000
General Installation
Installation of the CPN 5600/6000 can be divided into the
following four areas:
• Connect Video Sources and Outputs
• Connect Controllers
• Connect LAN
• Power Up
Connect Sources & Outputs
Composite or Y/C (S-Video) Connectors
The video inputs on the CPN-5600 support either two composite
inputs or a single input of Y/C (S-Video). For Y/C, both BNC
connectors are used. One connector carries the "Y" information
and the other carries the "C" information.
Using a BNC cable, connect a Pointmaker COMPOSITE INPUT
connector to the video output connector on a composite
video source. You can repeat this process with the second
COMPOSITE INPUT connector.
Connecting Y/C (S-video) can be accomplished using a "Y"
adapter cable (also known as a breakout cable) with two male
BNC connectors at one end and an S-video connector at the
other end.
Connect the two BNC connectors to the Pointmaker Y and C
INPUT connectors, and the S-video connector to a S-video
output connector on a S-video source.
VGA Connectors
Using a VGA video cable, connect a VGA INPUT connector to a
video output connector on a VGA video source.
Using a VGA video cable, connect the VGA OUTPUT connector
to a VGA display device.
Connect HDMI Devices
Note: Only output 3 is HDCP compliant in the CPN-5600.
Outputs 2 and 3 are both HDCP compliant in the CPN-
6000.
To connect HDMI Input:
Using a HDMI video cable, connect the CPN 5600/6000 HDMI
input connector to a HDMI output connector on a HDMI video
source.
To connect HDMI Output:
Using a HDMI video cable, connect the CPN 5600/6000 HDMI
output connector to a HDMI output connector on a HDMI video
source.
Connect Touch Screens & Electronic Whiteboards
For USB Touch Screens, connect all video sources before
connecting the USB cable and extension to the USB port.
For any touch screen, be sure to calibrate the touch screen on
start up. See "Calibrating CPN 5600/6000 Controllers" on page
2 for the calibration process.
Connect USB Devices
Connect the device(s) to any USB port on the CPN 5600/6000.
The system supports up to 4 USB 3.0 devices and 1 USB B
device.
Connect Other Controllers
The following categories of controllers can be used with the CPN
5600/6000:
• Keyboard
• Touch Screens/Electronic Whiteboards
• Tablets
• Mouse devices
IMPORTANT: Be sure to power down the CPN 5600/6000
before connecting or disconnecting any controllers.
The CPN 5600/6000 will automatically detect the installed
controllers upon power up. If you change controllers or add
a new controller, you need to power down, install the new
controller(s), then power up.
Front Panel
QUICK START GUIDE
© 2019, Williams AV LLC MAN 256A
Need help?
Do you have a question about the Pointmaker CPN 5600 and is the answer not in the manual?
Questions and answers