Related Manuals for enertexbayern Enertex KNXnet/IP Interface
Summary of Contents for enertexbayern Enertex KNXnet/IP Interface
- Page 1 Manual and Configuration KNXnet/IP Interface Enertex ® Bayern GmbH – Ebermannstädter Straße 8 - 91301 Forchheim - Deutschland - mail@enertex.de...
-
Page 2: Table Of Content
1150-HB-KNXnetIP-Interface-en-1.odt, 2018-08-06 Seite 2 von 6 Note The contents of this document may be reproduced without prior written approval by Enertex® Bayern GmbH in any form, neither in whole nor in parts, copied, transmitted, distributed or stored. Enertex® is a registered trademark of Enertex® Bayern GmbH. Other product and company names men- tioned in this manual may be the marketing or trade names of their respective owners. - Page 3 1150-HB-KNXnetIP-Interface-en-1.odt, 2018-08-06 Seite 3 von 6 Notices Installation and assembly of electrical equipment must be performed by qualified electri- • cians. When connecting KNX/EIB interfaces skills are provided by KNX™-Training. • Ignoring the instructions may damage the device as well as causing fire or other ha- •...
-
Page 4: Functional Description
1150-HB-KNXnetIP-Interface-en-1.odt, 2018-08-06 Seite 4 von 6 Functional Description Four independent KNXnet/IP tunnel connections • LED-signaling for KNX communication, Ethernet communication and programming mode • Standard configuration with ETS • Configuration of the tunnel addresses via Telnet • Parameterization The device can be parameterized with ETS3, ETS4 or ETS5. It supports up to four tunnel connections. - Page 5 1150-HB-KNXnetIP-Interface-en-1.odt, 2018-08-06 Seite 5 von 6 Telnetserver A integrated Telnet server provides additional functionalities. The default password for Telnet ac- cess is „knxnetip“. Reset the device to factory default and restart factory_reset Show IP settings ifconfig Sys multicast: multicast address for system telegrams RT multicast: multicast address for routing telegrams Close Telnet session logout...
-
Page 6: Technical Data
1150-HB-KNXnetIP-Interface-en-1.odt, 2018-08-06 Seite 6 von 6 Show tunnel addresses and connection status (without option), or show detailled information tunnel [1..5] for a specific tunnel (option 1..5) CCID: connection id of the tunnel connection KNX address: tunnel address HPAI control: control-end-point of the receiver HPAI data: data-end-point of the receiver Connect.
Need help?
Do you have a question about the Enertex KNXnet/IP Interface and is the answer not in the manual?
Questions and answers