Presetting Radio Stations; Tuning To Preset Stations - Sony HT-DDW840 Operating Instructions Manual

Presetting radio stations

1
Press TUNER.
The last received station is tuned in.
2
Tune in the station that you want to
preset using Direct Tuning (page 31) or
Automatic Tuning (page 32).
3
Press MEMORY.
"MEMORY" appears in the display for a
few seconds.
Do steps 4 to 6 before "MEMORY" goes
out.
4
Press SHIFT to select a memory page
(A, B or C).
Each time you press SHIFT, the letter "A",
"B", or "C" appears in the display.
5
Press PRESET TUNING +* or PRESET
TUNING –* to select a preset number.
If "MEMORY" goes out before you press
the preset number, start again from step 3.
6
Press MEMORY again to store the
station.
If "MEMORY" goes out before you can
store the station, start again from step 3.
7
Repeat steps 2 to 6 to preset another
station.
* For models of area code CEL, CEK: PRESET/PTY
SELECT + or PRESET/PTY SELECT –.
To change a preset number to
another station
Do steps 1 to 6 to preset a new station to the
number.

Tuning to preset stations

You can tune the preset stations by either of the
following two ways.
Scanning the preset stations
1
Press TUNER.
The last received station is tuned in.
2
Press PRESET TUNING +* or PRESET
TUNING –* repeatedly to select the
preset station you want.
Each time you press the button, the receiver
tunes in one preset station at a time, in the
corresponding order and direction as
follows:
nA1˜A2˜...˜A0˜B1˜B2˜...˜B0N
nC0˜...C2˜C1N
* For models of area code CEL, CEK: PRESET/PTY
SELECT + or PRESET/PTY SELECT –.
Using the preset codes
Use the supplied remote to perform the
following operations. For details on the buttons
used in this section, see pages 39–45 for remote
RM-PP411 and pages 46–49 for remote
RM-U306.
1
Press TUNER on the remote.
The last received station is tuned in.
2
Press SHIFT to select a memory page
(A, B, or C), then press the preset
number of the station you want using
the numeric buttons.
GB
33