Related Manuals for BATHCO Vanity
Summary of Contents for BATHCO Vanity
- Page 1 Vanity Installation Instructions Contents Getting started Required tools & materials Vanity installation Hinge adjustment Soft close drawers Trouble shooting Plumbing recommendations Cleaning & maintenance Bath Co Warranty...
-
Page 2: Getting Started
Any wall to which product is fixed must be of suitable construction to support that product’s weight. Silicone Sealant Cleaning materials Vanity Installation PLEASE READ CAREFULLY — IT IS RECOMMENDED THAT A QUALIFIED, LICENSED TRADES PERSON INSTALL YOUR UNIT. ENSURE INSTRUCTIONS ARE PASSED TO HOMEOWNER. - Page 3 06. Securely fasten unit to wall through the back, no further than 100mm from end of cabinet. Upper fixings no lower than 50mm from top of back. It is a requirement to fasten the cabinet through the steel bracket in the top corner of unit (refer to image 06). Secure here 07.
- Page 4 Soft Close Drawers When a cabinet has soft close drawers, the drawers will need to be removed prior to installation of the cabinet. Please view the following instructions on how to remove the drawers. Removal When you pull the drawer out you will notice a grey label on each side of the drawer (as per below diagram). When the label on each side is removed –...
-
Page 5: Trouble Shooting
» Waste overflow hole opening must not be blocked by sealant. » Basins with fixing holes must be bolted back to the wall separately from the vanity unit. Cleaning & Maintenance » To maintain the finish on your unit and top, only use a soft cloth, or a weak solution of non-abrasive detergent. - Page 6 This warranty is not transferable. Auckland 4–8 Ace Place, Kingsland | Tel 09 309 9109 | Fax 09 309 9343 Christchurch 86 Wigram Road | Tel 03 343 0969 | Fax 03 343 0967 Email: info@smail.co.nz BATHCO.CO.NZ...
Need help?
Do you have a question about the Vanity and is the answer not in the manual?
Questions and answers