Vent Blockage Test - Samsung DVE52M8650 Series User Manual

Hide thumbs Also See for DVE52M8650 Series:
Table of Contents

Advertisement

Available languages

Available languages

Installation
STEP 6 Power on (Gas models)
Make sure all gas connections, the exhaust line, and all wiring is connected correctly. Then,
plug the power cord into a power source and check the dryer's installation and operation
using the final checklist in Step 7 below.
STEP 7 Final Check
When installation is complete, confirm that:
• The dryer is plugged into an electrical outlet and grounded properly.
• The exhaust ductwork is connected and the joints are taped.
• You have used rigid or stiff-walled flexible metal duct material, not plastic flexible duct.
• The dryer is level and is sitting firmly on the floor.
• The dryer starts, runs, heats, and shuts off properly.
For gas models:
• The gas is supplied properly with no leaks.
CAUTION
The burner may not ignite initially due to air in the gas line. Allowing your dryer to
operate on a heat setting will purge the line. If the gas does not ignite within 5 minutes,
turn your dryer off and wait 5 minutes. Be sure the gas supply to your dryer has been
turned on. To confirm gas ignition, check the exhaust for heat.

Vent blockage test

After the dryer is installed, start the Vent Blockage Test to check if the duct system is
properly installed. The Vent Blockage Test automatically detects the status of duct and
reports any blockage or problems to the user. Proper ducting can reduce drying time and
save energy.
NOTE
The Vent Blockage Test must run at cool state. If the dryer warms up after the installation
check, run the AIR FLUFF cycle for several minutes to reduce its internal temperature.
Operation method
1. Make sure the drum is empty and close the door.
(If there are any clothes or other items in the drum, a correct test can not be made.)
2. Press the POWER button to turn the dryer on, then simultaneously press and hold the
Cycle 1 + Wrinkle Prevent buttons for 3 seconds.
When entering the Vent Blockage Test, "InS" appears in the display.
(If other procedures are started before entering the Vent Blockage Test, the dryer does
not enter the Vent Blockage Test.)
24
English
DV8650M_DC68-03170X-05_EN.indd 24
2019-06-03
5:08:13

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dveg52m8650 series

Table of Contents