Using Wifi - ACR Electronics AISLink CB2 User Manual

3.1 Using WiFi

An Internet connection is required
!
From the Google Play Store or the Apple App Store search for ACR AIS Confi g.
Install the ACR AIS Confi g App on your mobile device.
To set-up a WiFi connection with your mobile device (initial connection only):
Turn off the power to the CB2.
Press and hold the LED button and turn on the power. Keep the button held for 6 seconds
until the LED turns Red following Amber fl ashes. Release the button and the LED should
remain Amber, blinking off every 2 seconds to indicate the CB2 is in Wi-Fi connection
mode.
Open the App on your mobile device and press Search to look for available devices (this
may take a few moments). Once the search has completed, select the CB2 to pair with
your mobile device (for iOS only, this is automatic using Android).
Use the Android or iOS app to upload the vessel information to your paired CB2.
3.2 Using a USB Device
Your vessel information can be transferred from your Android phone or computer/laptop to
the CB2 using a USB stick and the provided on the go cable.
Ensure the CB2 is powered off before inserting the USB stick.
!
Once inserted, power on the unit. The CB2 will upload the information from the USB stick
automatically. This may take a few moments. Once the LED stops fl ashing and a steady
Green or Green/Amber fl ashing* light can be seen, the information is stored.
Press and hold the LED button for 10 seconds, the LED will start to fl ash Red/Amber and
on release will alternate Green and Amber to allow the USB stick to be safely removed
without corruption. The LED will revert to normal operation once the USB stick is removed.
You can use the Android App (see above) or the web-based software to upload vessel
information onto the USB Stick. The web-based software is available at
www.acrartex.com/ais_confi g .
* Dependant on whether LRM is turned on
CB2 Manual
Y1-03-0346 Rev. B 13