Tire Pressure And Wheel Hardware Torque - New Holland L213 Operator's Manual

Skid steer loader. compact track loader
Hide thumbs Also See for L213:
Table of Contents

Advertisement

Tire pressure and wheel hardware torque

WARNING
Explosion hazard!
Always maintain correct tire pressure as indicated in this manual. DO NOT inflate tires above the
recommended pressure. Excessive pressure could result in tire failure.
Failure to comply could result in death or serious injury.
WARNING
Explosion hazard!
Tires must be replaced by skilled personnel with the proper tools and technical knowledge. Unskilled
personnel replacing wheels or tires could result in serious physical injuries, tire damage, and/or wheel
distortion. Always have a qualified tire mechanic service wheels and tires.
Failure to comply could result in death or serious injury.
The skid steer will be hard to turn and the tires will wear faster if the correct pressure is not maintained. When a
worn or damaged tire is replaced, the replacement must be the same size and tread design as the other tires on the
machine. Two different sized tires on one side of the machine will cause accelerated tire wear, loss of power, and
excessive strain on the drivetrain. Replace worn tires in pairs with the two new tires used on the same side of the
loader. If this tilts the loader too much, replace all four tires.
Adding air to the tire
NOTICE: Tire pressure gauges should be checked at regular intervals for calibration and accuracy.
1. Check the tire pressure.
2. Before you add air, have the wheel correctly installed
on the machine or put the wheel in a restraining device
(tire inflation cage).
3. Use an air hose with a remote shutoff valve, self-locking
air chuck and wear eye protection.
4. Stand BEHIND the tread of the tire and make sure ALL
persons are away from the side of the tire before you
start to add air.
5. Inflate the tire to the recommended air pressure. DO
NOT inflate the tire more than the recommended max-
imum pressure given on the tire.
TIRE
Heavy Duty
Premium
Premium with liner
Severe Duty
Flotation
Mining
Non-Pneumatic
7 - MAINTENANCE
SIZE
10 x 16.5
12 x 16.5
14 x 17.5
27/10.5 x 15
10 x 16.5
12 x 16.5
14 x 17.5
10 x 16.5
12 x 16.5
10 x 16.5
12 x 16.5
14 x 17.5
31.5 x 13 x 16.5
33 x 15.5 x 16.5
12 x 16.5
12 x 16.5
14 x 17.5
7-27
PRESSURE
290 – 345 kPa (42 – 50 psi)
359 – 414 kPa (52 – 60 psi)
290 – 345 kPa (42 – 50 psi)
359 – 414 kPa (52 – 60 psi)
290 – 345 kPa (42 – 50 psi)
290 – 345 kPa (42 – 50 psi)
531 – 586 kPa (77 – 85 psi)
179 – 241 kPa (26 – 35 psi)
290 – 345 kPa (42 – 50 psi)
290 – 345 kPa (42 – 50 psi)
not required
W0109A
W0171A

Advertisement

Table of Contents
loading

This manual is also suitable for:

200 seriesL223L215L225L218L230 ... Show all

Table of Contents