Advertisement
OUTDOOR UNIT
Pinhole camera
1
Capture visitor s image outside to send to TFT display
Call button
Call indoor unit by pressing this button
2
3
Installation stud
Keep outdoor unit mounted on the door
4
Connection cable
Connect indoor unit to outdoor unit
◆
VISITOR CALL
Monitoring mode
Indoor unit is in standby status
The Visitor presses
Two continuous tones
the
call
button on
are heard inside
outdoor unit
Press the monitoring
The screen will be on
button on the indoor
unit
NOTICE:
1.The picture can be stored in the SD card or internal memory.
2.The screen will display
Enable SD CARD
3. The system will automatically return to the standby mode if there is no
operation in 10 seconds .
5
The screen will be
'
Two seconds later, the visitor s
off automatically 10
image will automatically display on
second later
the screen for 10s and picture
will be captured
The screen will be
Press the monitor button
off automatically 10
again to capture the picture
second later
after the SD card is installed.
Browsing mode
Press the monitoring
Switch the image
button on the indoor
displayed on the screen
unit
DEL?
Press the left arrow
Y
N
button to choose the
image you intend to delete
The system will automatically return to the standby mode if there is no operation
in 10 seconds .
Time
& d
ate mode
Press the monitoring
Switch the image
displayed on the screen
button on the indoor
unit
Press the monitoring
button to choose the
item .
1.This setting will stamp the
time
and
2.After finishing the setting and hold monitoring button for 3s to return to the
monitoring mode.
Press it again
Press the right arrow
to view next
button to view photos
image
recorded on SD card
Press monitoring
Press left arrow again to delete,
button to return
press right arrow to choose N,
to monitoring
press left arrow again to cancel.
status
Press the left arrow
Time
& d
ate
the blue screen
button to go into
date & time mode
Press the left arrow
to increase and right
arrow to decrease.
date
on a photo recorded in the SD card.
on
6
Advertisement
