Advertisement
INSTALLATION PROCESS
Please follow the steps
below
to install the units:
Step1
Step2
Step5
Step6
Step9
Step10
1. Drill a hole ( D=13mm) on the door at the height of 150cm from the ground or
use existing hole where Cat-eye is located.
2.
Mount the external connector on the bracket by using 3 screws.
3.
Screw off the installation stud.
4.
Take the outdoor unit into the hole.
5. Fix both outdoor unit and the bracket with installation stud.
6. Fasten connection cable.
7. Take
off
the front panel according to step7
8. Push the indoor unit along the limited-slot on the bracket.
9. Fasten the indoor unit.
10.Connect with the Li-battery.
11.Put on
the front panel and finish installation.
3
Step3
Step4
Step7
Step8
Step11
OPERATION INTRODUCTION
INDOOR UNIT
1
Indicating Li-battery charging status
LED indicator
'
2 TFT display
View a visitor s image displayed on TFT screen
3 Right arrow
Browse all the photos recorded on SD card
Monitoring button
4
Monitor outside
Left arrow
Set time and date for captured pictures
5
6 Extended-slot
Extended-slot for SD card
7
USB interface
Download all photos via a USB cable
Terminal
20-pin terminal connected to the external connector
8
9
Installation hole
Fix the indoor unit on it with screws
4
Advertisement
