Promaster Still Life studio 2.0 Instructions

Version 2.0

Included Parts

•
Studio shell fabric / case x 1
•
Diffusion panel x 1
•
LED light strips x 2
•
AC power supply x 1
•
Vinyl backgrounds x 4

Assembly

1) Lay the case on a flat surface with the [pro]master logo facing up.
2) Remove any items which may be in the pouch on the front of the case and set these
items aside for now.
3) Open the case and fold out each of the panels flat.
4) Bring the panels together, edge-to-edge, one at a time pressing their sides together for
a firm attachment. Build a cube by doing this.
5) Set the assembled cube out so the panel with the [pro]master logo becomes the front.
6) Choose one of the 4 backgrounds.
7) Open the top flap of the cube.
8) Attach the background to the back, inside of the cube using the hook and loop
fasteners.
9) Roll the background down to the back, inside portion of the cube and across the
bottom. Then tuck the end of the background into the seam at the bottom, front edge
of the cube to keep it in place
10) Close the top panel of the cube. Your background is installed and ready.
11) Now open the front panel of the cube.
12) Locate the two LED light strips and insert them into the inside, top panel of the cube by
siding them into the elastic bands. Be sure the LED lights are facing down into the cube
and the power cords on the LED light strips are oriented towards the back of the cube.
13) Route the two power cables through the small hatch near the back of the top panel.
14) Locate the white diffusion panel. Connect its 4 corners to the inside of the cube by
joining the hook and loop fasteners on the diffuser with the white hook and loop tabs
inside the cube in each of its corners. Be sure the fabric hatch in the diffuser is oriented
downward so it can easily be opened and closed.