Sony LBT-ZUX9 Operating Instructions Manual page 26

REC1 Recording
Recording
source
MP3 disc
AUDIO CD
1)
In Program Play mode, the folder name is
"FLDRxxx", and the track name depends on
the recording source (AUDIO CD or MP3
disc).
2)
Up to 32 characters of the name are assigned.
3)
XXX is the folder number from 001 to 997.
4)
XXX is the track number from 001 to 999.
5)
A new track is recorded in the "REC1" folder
each time REC1 recording is performed.
Notes
• Do not connect the system and the USB
device through a USB hub.
• You cannot eject the disc during CD-USB
Synchro Recording or REC1 Recording.
• When recording from an AUDIO CD, the
tracks are recorded as 128 kbps MP3 audio
tracks.
When recording from an MP3 disc, MP3
audio tracks are recorded with the same bit
rate as the original MP3 audio tracks.
• While recording from an MP3 disc, no sound
is output and "High Speed Recording"
appears in the display.
• If you cancel the recording halfway, an MP3
audio track is created up to the point when the
recording was stopped.
• Recording stops automatically if:
– the USB device runs out of space during
recording.
– the number of MP3 audio tracks on the USB
device reaches the limit for the number that
the system can recognize.
26 US
Folder name Track name
Same as the
recording
5)
REC1
source
TRACKXXX
• The maximum number of MP3 audio track
folders that can be recorded on a single USB
device by this system is 997.
The maximum number of MP3 audio tracks
that can be recorded on a single USB device
by this system is 999.
The maximum number of MP3 audio tracks
2)
and folders may vary depending on the MP3
4)
audio track and folder structure.
• For MP3 disc, if a folder or track that you are
trying to record already exists on the USB
device with the same name, a sequential
number is added after the name without
overwriting the original folder or track.
• If you perform recording after the erase
operation, the new recorded tracks or folders
may have the name that same as the erased
tracks or folders. Therefore, the playback
sequence may different from the recording
sequence.
• When you perform CD-USB Synchro
Recording or REC1 Recording, the following
would not be recorded:
– sound from microphone.
– beat sound from drum pads or beat pattern.
– effector mode sound.