Initial Cleaning And Sanitizing; Initial Start-Up - Silver King SK-1 Manual

Initial Cleaning and Sanitizing

Make sure that the
1
switch on the back
of the unit is in the
"off position". The
indicator panel should
be unlit
Wash the surfaces of the unit with warm, soapy
2
water.
Rinse the surfaces with warm water.
3
Turn the valve
4
insert. Pull and
turn valve to ex-
pose cold block.
Clean the valve and valve area. Use a brush and warm,
5
soapy water to clean the valve. Clean the valve area of the
dispenser with a brush and warm, soapy water. Rinse with
warm water.
Sanitize the valve and valve area. With an approved
6
sanitizing solution, thoroughly clean the valve and valve
area. Allow to air dry.
SK-1 Cream Dispenser
366-155

Initial Start-Up

1
Power Switch
2
3
6
Place the switch on
the back of the unit in
the "on" position. The
indicator panel should
display the current unit
temperature.
Allow the unit to run a minimum of two hours be-
fore loading it with product.
Note: It is completely normal for the exterior of the unit
to feel warm while it is running.
Load cream into the cream dispenser. Once the
unit has achieved proper operating temperature,
observe the procedures noted in the label on the
door liner for loading cream in the cream dispenser
Printed in USA 10/15