HDMI, DVI, SDI, HDBT, VGA, Component video and Composite video. Features The SY-MMU range supports HDMI and HDBT video sources and displays up to 4K resolution Up to 8, 16, or 32 inputs (from media players, blue-ray players, … sources) ...
Page 3
Selection buttons for output channels AV Button Starts a new Audio & Video selection sequence Video Starts a new Video Only selection sequence – SY-MMU-88A only Audio Starts a new Audio Only selection sequence – SY-MMU-88A only Comma Separates output selections – SY-MMU-1616 and higher Enter Completes a new command entry –...
Page 4
Note that the SY-MMU-88A has only one IEC mains connector, whereas all the other Matrix Switchers have two IEC connectors, see below for more details. Note that the analogue audio switcher section on the SY-MMU-88A does not transfer any audio signals to or from the video switcher section.
Page 5
Configuring the SY-MMU Range of Matrix Switchers The input and output cards requested at time of purchase should already be installed in the matrix switcher upon receipt. If this is not the case please contact your local dealer or SY directly to have this problem addressed.
Page 6
SY-MMU-88A / 1616 / 3232 / 6464 Figure 9 - SDI Video Input and Output Cards The input card can only accept SDI video signals, whereas the output card will output SDI video signals from any input card. 4Kx2K Input and Output Cards Any 4K input or output card can be identified by the 4K icon on the outer edge of the connector panel.
Page 7
IEC Connectors Note that the SY-MMU-88A Matrix Switcher has only a single IEC connector, whereas all the other Matrix Switchers have two IEC connectors. Where there are two IEC connectors provided they should each be connected to different ring or spur circuits such that if one ring or spur were to fail, then the other ring or spur will continue to keep the Matrix Switcher operating.
INPUTS group and 4 is in the OUTPUTS group. Video and Audio Buttons (SY-MMU-88A Only) Note that the SY-MMU-88A Matrix switcher also has Video and Audio buttons, these can be used to independently switch only the video signal or only the audio signal where these signals are provided separately.
SY-MMU-88A / 1616 / 3232 / 6464 Using IR Remote Controls Point the IR remote control key pad at the SY-MMU Matrix Switcher and use the key pad buttons in the same sequence as for using the front panel controls.
Page 10
SY-MMU-88A / 1616 / 3232 / 6464 Action Command Response Select an Audio inputs (x) to a single (Note 3) output (y) xAy. (x is the input number, y is the output number) Select an Audio input (x) to multiple...
Page 11
2. When selecting multiple outputs for an input, each output must be separated by a comma ( , ) and may appear in any order. 3. The A command is only supported by the SY-MMU-88A Matrix Switcher. 4. The B command (Select both Audio and Video) is the only video selection command that is compatible to all matrix switchers in the SY-MMU range.
150 W 200 W Environmental Operating Temperature 0 - 40 °C non condensing Physical All the matrix switchers in the SY-MMU range are full width 19in rack mounting with integral fixing holes and handles. Product SY-MMU-88A SY-MMU-1616 SY-MMU-3232 SY-MMU-6464 Width 483 mm (19”)
Page 14
Damage to the product due to incorrect usage or storage Damage caused by unauthorised repairs Damage caused by mistreatment of the product 5. Please direct any questions or problems you may have to your local dealer before contacting SY Electronics. www.sy.co.uk...
Need help?
Do you have a question about the SY-MMU Series and is the answer not in the manual?
Questions and answers