Table of Contents
Advertisement
Warning: After the appliance is installed you should
n
n
make sure you can access the electrical isolation
point.
Electrical Safety
The electrical installation must be installed in accordance
with all relevant British Standards/Codes of Practice, BS 7671.
Or with the relevant national and local regulations and with
the local gas and electricity supply companies' requirements.
Otherwise, all installations must be in accordance with the
relevant instructions in this booklet.
Read the instructions before installing or using this appliance.
The appliance may be installed in a kitchen/kitchen diner but
NOT in a room containing a bath or shower.
This appliance MUST be earthed.
The appliance MUST NOT be fitted with plug and connected
to a wall socket. Refer to "Electrical Connection" on page
36.
The appliance must be installed in accordance with the
regulations in force and only in a well ventilated space.
Failure to install the appliance correctly could invalidate any
warranty or liability claims and lead to prosecution.
DO NOT install the appliance on a loose platform. The
appliance is heavy and may tip if not adequately secured.
Refer to "Installation" on page 33.
DO NOT manouvre the appliance while it is connected into
the electricity supply.
If the appliance does not operate successfully, DO NOT
attempt to repair. Turn it off using the main switch (Refer to
the overview chapter) unplug from the mains socket and
contact customer services.
If the plug or powder cable is damaged, it must be replaced
by the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard.
Installation and Maintenance
DO NOT install the appliance on a loose platform.
n
n
The appliance is heavy and may tip if not adequately
secured. Refer to "Installation" on page 33 before
proceeding installation of your appliance.
It is recommended that this appliance is serviced annually.
Only a qualified service engineer should service the
appliance, and only approved spare parts should be used.
Make sure that the appliance is wired in and switched on.
Always allow the appliance to cool and then switch it off at
the mains before cleaning or carrying out any maintenance
work, unless otherwise specified in this guide. Refer to
"Installation" on page 33 and "Electrical Connection"
on page 36 before proceeding installation of your
appliance.
Provision for Ventilation
The appliance housing used must provide adequate
ventilation.
For built-in installation, a minimum ventilation space of 85 –
90mm 40mm must exist between the rear of the appliance
and the back of the housing or an adjacent wall.
If a tall housing is to be installed flush with the ceiling, a
20cm² ventilation cut-out must be provided at the top of the
housing.
Location of the appliance
Do not install the appliance in rooms where the
n
n
temperature may drop to 0°C or lower (the water in
the appliance could freeze and cause damage).
The appliance may be installed in a kitchen/kitchen diner but
NOT in a room containing a bath or shower.
This appliance is designed for domestic cooking only. Use for
any other purpose could invalidate any warranty or liability
claim.
Cleaning
In the interests of hygiene and safety, the appliance should
be kept clean at all times.
Clean only the parts listed in this guide.
Clean with caution. If a wet sponge or cloth is used to wipe
spills on a hot surface, be careful to avoid steam burns. Some
cleaners can produce noxious fumes if applied to a hot
surface.
2
Hide quick links:
Advertisement
Table of Contents
