Haier HWF12D1W1 User Manual page 12

Troubleshooting
In case of power failure
The current programme and its setting will be saved.
When power supply is restored, operation will be
resumed.
If a power failure cuts an operating wash programme
door opening is mechanically blocked. To get out any
laundry water level should not be seen in the glassy
porthole of the door. - Danger of burns! Water level has
to be lowered as described in "Pump filter". Not till then
pull lever (A) beneath service flap until door is unlocked
by a gentle click. Afterwards refix all parts.
Troubleshooting without display code
Problem Cause
1. Power failure
Washing machine
2. Machine hasn't been switched
fails to operate.
on.
3. Door is not p roperly closed.
4. P rogramme is not yet started
5. Child lock is activated.
1. No water
Washing machine
2. Inlet hose is kinked.
will not fill with
3. Inlet hose filter is blocked.
water.
4. Water pressure is less than
0.03Mpa.
5. Door is not properly closed.
6. Water supply failure.
1. Height of d rain hose is bel ow
Machine is
80cm.
draining while
2. Drain hose end could reach
being filled.
into water.
1. Drain hose is bloc ked.
Drainage failure.
2. Pump filter is blocked.
3. Drain hose end is higher than
100cm above floor level.
22
Solution
1. Check power supply.
2. Switch the machine on.
3. Close the door p roperly.
4. Press "START/PAUSE"
button.
5. Deactivate child lock.
1. Check water tap.
2. Check in let hose.
3. Unblock inlet hose filter.
4. Check water pressure.
5. Close the door properly.
6. Ensure the water supply.
1. Make sure that drain hose is
properly installed.
2. Make sure the drain hose is
not in water.
1. Unblock drain hose.
2. Clean pump filter.
3. Make sure that drain hose
is properly installed ..
23
Problem Cause
1. Not all t ransportation bolts
Strong vibration
have been removed.
while spinning.
2. Applian ce has no solid
position.
3. Machine load is not correct.
Operation stops
1. Appliance displays error code.
for a period of
2. Problem due to load pattern.
time.
Water or electric failure.
Operation stops
before completi-
ng wash cycle.
Excessive foam
1. Detergent is not a app ropriate.
floats drum and/or
2. Excessive use of detergent in
detergent drawer. manually dosag e.
Washing programme
Automatic adjust-
ment of washing duration will be adjusted.
time
Unbalance of laundry.
Spinning fails
General information and tips:
If too much foam is visible during spin cycle, the motor will stop and drain
pump will activate for 90 seconds. If that elimin ation of foam fails up to 3
times, p rogramme ends without spinning.
Troubleshooting
Solution
1. Remove all transportation
bolts.
2. Ensure solid ground and
a levelled position.
3. Check load weight and
balance.
1. Consider display codes.
2. Reduce or adjust load.
Check power and water
supply.
1. Check de tergent recom-
mendations.
2. Reduce amount of deter-
gent.
This is normal and doesn't
aff ect functionality.
Check machine load and
laundry and run a spinning
programme again.