What's In The Ez-Guide Plus Box; Accessories And Upgrades - Hardi EZ-Guide Plus Getting Started Manual

EZ-Guide® Plus

What's in the EZ-Guide Plus Box?

When you receive your EZ-Guide Plus system, check that you have
received all the components, as detailed on the packing list. The fol-
lowing diagram shows the standard components.
Note — The antenna, antenna cable, magnetic mount, and metal
plate are included only if you purchased the system with integrated
GPS.
Caution — Keep the lightbar dry. Do not spray the lightbar with any
type of liquid as this will cause it to fail.
Inspect all contents for visible damage, such as scratches or dents. If
any components appear damaged, notify the shipping carrier. Keep
the shipping and packaging material for the carrier's inspection.
Installing the System
1. Assemble the bracket kit. The bracket is reversible to optimize it for tilt angle. For more information, refer to
the instruc- tions in the bracket kit.
2. Attach the suction cup to the bracket.
3. Attach the power cable to the lightbar.
4. Mount the lightbar in the required position on the window. See Mounting the lightbar.
5. Attach the antenna to the magnetic mount.
6. Connect the antenna cable to the antenna and route the cable to the cab.
7. Attach the magnetic mount to the cab roof, along the vehicle centerline. Do one of the following:
– If the cab roof is steel, attach the magnetic mount directly to the roof.
– If the cab roof is not steel, attach the metal plate to the cab roof. Then attach the magnetic mount to the metal plate.
8. Connect the antenna cable to the lightbar.
9. Plug the power cable into the vehicle cigarette lighter. See Using the vehicle cigarette lighter, page 3.
4