Download From Driver Card - inelo TachoReader Combo Plus Tutorial

Download from driver card

8. Download from driver card
Downloading driver card data directly from the TR Combo Plus slot can be accomplished in
several ways, depending on the type of power supply of the unit:
1. When battery-powered (stand-alone operation) - insert the battery/rechargeable batteries to
the device socket. (see:
2. When powered from the tachograph - connect TR Combo Plus with the tachograph via Tacho
RC cable .
3. When powered from the computer - connect TR Combo Plus to a computer via the Mini-USB
cable .
TR Combo is able to download data from a driver card inserted in the slot of the tachograph - see:
"Download from driver card inserted in the tachograph
Download procedure
1. Insert the batteries/rechargeable batteries to TR Combo Plus or connect the device to a
different power source (see the description above).
2. Insert the driver card into the
Data download is started automatically when you place the driver card in the device slot.
Download progress will be indicated by a single beep and incremental lighting up the
LEDs on the progress bar.
If during data retrieval red LED located in the center of the label lights up for about 4 seconds, and in
this time the device sounds three short beeps, then it goes off for about 2 seconds (repeatedly), this
means an error occurred - refer to the
"Battery change " topic for more).
23
slot of TR Combo Plus .
Fig. TachoReader Combo Plus - inserting a driver card.
"Error codes
" topic for more.
18
" topic.
21
17