WilTec 50 l Operation Manual page 4

Prevent children or other persons from coming into contact with the compressor power cord. En-

sure that all unauthorised persons maintain a safe distance from the working area.
Keep the working area clean and remove any unused tools. Ensure good ventilation of the work

area. Do not use the compressor in environments containing paint, petrol, chemicals, adhesives or
other flammable or explosive substances.
When the compressor is not in use, it must be stored in a dry place and protected from the

weather. It must be stored out of the reach of children.
Do not transport the compressor if it is still connected to an electrical power source or if the boiler

is under pressure. Before connecting the compressor to an energy source, make sure that the
switch of the pressure switch is in the OFF position.
Before carrying out any repair, inspection, maintenance, cleaning or component replacement

work, the compressor must be disconnected from the mains supply and the pressure released
from the boiler.
Never use the compressor near water or in a humid environment.

Always wear protective glasses or eye protection. Never point the compressed air jet at your own

body or at other persons.
Never operate the compressor unless all guards (e.g. guards, belt guards, safety valve) are prop -

erly installed. If maintenance or repair work necessitates the removal of the guards, make sure
that they have been properly reattached before restarting the compressor.
Never place your hands, fingers or any other parts of your body near moving parts.

WORK WITH COMPRESSED AIR AND BLOW GUNS
Compressors and lines reach high temperatures during operation. Avoid touching these parts as

this can cause burns.
The air sucked in by the compressor must be kept free of gases, vapours and admixtures, which

can lead to fire or explosion in the unit.
When releasing the hose coupling, be sure to hold the hose coupling piece by hand to avoid injury

from the hose coming out.
Always wear protective goggles when working with the blow gun. Blown foreign bodies and parti -

cles can easily cause injuries.
Never point the blow gun at persons.

Never clean clothes on the body with the blow gun.

WORKING WITH PAINT SPRAYERS
Do not use varnishes or solvents with a flash point of less than 21 °C.

Never heat solvents or paints.

When processing liquids that are harmful to health, filter devices such as view masks are required

for protection. Please observe the information on further protective measures provided by the
manufacturer of these substances.
Do not smoke in the entire working area during the spraying process. Paint vapours are highly

flammable.
Paint vapours are harmful to health. Therefore do not store or consume any food or drinks in the

work area.
Note that the working area must be more than 30 m³. Sufficient air circulation during spraying and

drying is absolutely necessary.
PVC hoses must not be used with liquids such as white spirit, butyl alcohol or ethylene chloride,

as this can lead to a reduced service life of the compressed air hose.
Ensure that the intake air is clean, dry and dust-free.

Do not place the compressor in a wet or humid room.

DESCRIPTION
This compressor impresses with its new design and excellent operation. It has a very compact con-
struction, good appearance, low weight, easy handling, good safety and low noise level. It can be used
for machines, air-brushes and other devices.
© by WilTec Wildanger Technik GmbH
http://www.WilTec.de
http://www.aoyue.eu
http://www.teichtip.de
Seite 16