The Installation Menu - Sony VPL-FE40/FE40L Operating Instructions Manual

The Installation Menu

The Installation menu is used for changing the settings of the projector.
Lamp Mode
ID Mode
Illumination
Direct Power On
Setting items
V Keystone
Image Flip
Lamp Mode
Lens Control
IR Receiver
38
The Installation Menu
Standard
All
Functions
Corrects the vertical trapezoidal distortion of the picture.
When the bottom of the trapezoid is longer than the top
( ): Sets a lower value (– direction).
When the top of the trapezoid is longer than the bottom
( ): Sets a higher value (+ direction).
Flips the picture on the screen horizontally and/or
vertically.
Use this item for installation for the backside projection or
ceiling installation.
• HV: Flips the picture horizontally and vertically.
• H: Flips the picture horizontally.
• V: Flips the picture vertically.
• Off: The picture does not flip.
Sets the lamp brightness used during the projection.
• High: Illuminates the projected image brightly.
• Standard: Reduces fan noise and power consumption.
The brightness of the projected image will be lower
compared with the "High" setting.
Avoids any operation of the lens such as "Focus," "Zoom,"
and "Shift," by mistake.
When set to "On," you can adjust the projection lens
using "Focus," "Zoom," and "Shift." After you make this
adjustment, it is recommended that you set this item to
"Off" to avoid any operation of the lens. When set to
"Off," the FOCUS, ZOOM and SHIFT keys do not work.
Selects the remote control detectors (IR Receiver) on the
front and rear of the projector.
• Front & Rear: Activates both the front and rear
detectors.
• Front: Activates the front detector only.
• Rear: Activates the rear detector only.
Initial setting
0
Off
Standard
On
Front & Rear