Table of Contents
Advertisement
M
aintenance and care
cleaning the filter and screen
1.
Turn hand vacuum OFF (O).
2.
Unplug hand vacuum from electrical outlet.
3.
Press dirt container release latch down to discon-
nect dirt container and filter assembly from the unit.
4.
Remove filter by grasping tabs on both sides of
filter frame and pulling away from the dirt container.
5.
Separate filter assembly by grasping tabs
on both sides of assembly and pull. For best
results, periodically tap filter and screen
against trash can to remove dirt that has
collected on the screen and filter.
6.
Reconnect filter and screen by aligning
rectangular tab on filter with insert on screen.
Press together to ensure assembly is secure.
7.
See page 5 to reattach dirt container.
notE: Dirt container and screen may be
rinsed with cold water. Ensure both are dry
before reinserting.
Do not wash or rinse pleated filter.
Storage/cord wrap system
a wrap is always attached to the cord for quick
and easy storage.
1.
To store the unit, turn hand vacuum OFF (O).
2.
Unplug hand vacuum from electrical outlet.
3.
Bundle cord, using wrap that is located on
cord, to store.
nozzle and tools Maintenance
Keep nozzle and tools clean and free of debris by
wiping nozzle and tools clean with damp cloth.
T
roubleshooting
Hand vacuum won't turn on
Possible causes
1. Power cord not plugged in
2. Blown fuse/tripped breaker in home
Hand Vacuum won't pick up or low suction
Possible causes
1. Dirt container not installed properly
2. Dirt container is full
3. Filter or screen is dirty
4. Nozzle or hose is clogged with debris
6
w w w . b i s s e l l . c o m
ug110-4084_47R5_109.indd 6
4.
5.
6.
Insert
Remedies
1. Check electrical plug
2. Check/replace fuse or reset breaker
Remedies
1. Check assembly of dirt container making
sure it is securely in place
2. Empty dirt container and reattach
3. See instructions above. Replace filter if needed
4. Remove hose and tool and remove debris
5a.
Tab
8 0 0 . 2 3 7 . 7 6 9 1
12/30/2008 10:33:39 AM
Advertisement
Table of Contents
